- Details
-
December 29, 2022
-
Written by Jason Hance
The most common occurrences of violins in the Lifan Solano salon are rear door panels, rear racks, rear seat backs, dashboard and magnetolode
- Details
-
December 29, 2022
-
Written by Jason Hance
If the fuel level indicator on Honda Axord 7 is not working correctly, there are several possible reasons: 1) An electronic control system malfunction. It is necessary to ensure that the system does not issue B1175.2 error B1175.2) Defective fuse
- Details
-
December 28, 2022
-
Written by Jason Hance
If the climate control on Honda Accord 8 is not working properly, the sensors responsible for the normal operation of the system need to be checked first
- Details
-
December 28, 2022
-
Written by Jason Hance
To disassemble the front door on Lifan Solano, we do the following: Let' s take the "beams". For this screwdriver, wrapped in an oolt (to avoid damaging the paint), put it in the upper corner
- Details
-
December 28, 2022
-
Written by Jason Hance
(1) If FM-1 and FM-2 ranges are not switched on Honda Akcord 8, then the magnets need to be checked. When the A. Sel button is pressed, FM-2 mode does not work. Therefore, to solve the problem, press A again
- Details
-
December 27, 2022
-
Written by Jason Hance
There are sometimes creaks of plastic elements in the Honda Akord 8 salon. Also, the discomfort can deliver the creak of the back shelf. In order to get rid of it, it is usually necessary to tighten the fastenings and process the installation locations of the penetrating lubricant
- Details
-
December 26, 2022
-
Written by Jason Hance
If the back shelf on Accord 8 is creaking or creaking, the problem is most likely to be related to the features of metal welding in the trunk. It can be eliminated in several ways: (1) Back to the dealer if the car is under warranty
- Details
-
December 26, 2022
-
Written by Jason Hance
The improper adjustment of the pedal is a common cause of the scuffle or "waging" of the clutch of Lifan Solano. To verify that it is correctly positioned, take the ruler and measure the height of the pedal from the floor. It must be about 117 \ mm
- Details
-
December 25, 2022
-
Written by Jason Hance
To change or clean the salon filter it is necessary: (1) Open the front passenger door 2) Open the glove compartment and pull out the half-.3) onto the side tabs of the rear panel of the glove compartment and pull it out. 4) Lock the tabs on the sides of the salon filter body and pull it out
- Details
-
December 25, 2022
-
Written by Jason Hance
To check the combined light switch on the Honda Civil 8: Remove the bottom of the dashboard. Also remove the cover of the steering column. Then disconnect the connector "12R" from the central light switch