Vehicle interior

The rear seat cushion in Hyundai Accent holds two bolts for 12 and two screws. The bolts are at the edges of the seat, between the cushion and the back. Latches are located in the front of the pillow. In the middle of the pillow there is a knight.

In order to change the regular back dynamics on Lifan Solano, you can do the following: Take off the back couch to get access to the bolts of the sidewall of the chair. The back of the back seat

In the control of dust and fungal, the evaporator of the air conditioner is supported by the foam scrubbers of the evaporator of the air-conditioner. In the first case you need to remove the salon filter

To make the clutch pedal more comfortable, you need to move the driver's seat back as much as possible. The pedal mechanism looks like this: A work cylinder that includes a shock. It is mounted with a fork, which has a hard nut

Many of the "trackers" almost immediately after the purchase of the air conditioner fan. Sometimes during the launch, sometimes all the time. The fan is placed under the hood of the left if facing the bonnet.

To dismantle the console in Hyundai Accent, you need to move the coasters off and pull out the carrots behind them. Then the bottom up, pull the console out, it's in the latches. If you want to remove the entire drive, disconnect all the connectors and connections (the driver on the right and the bar)

To remove the permanent magnet plate, the filler panel must be removed and the screws on which the screws are located.

To remove the Mazda 3 (I) sensor without an anti-lock braking system, disconnect the AQA and remove it with the tray. Remove the air filter sensor element. Remove the connector from the connector

In Hyundai Accent, it is necessary to remove the back of the back shelf in order to remove the rear speakers. To do this, it is necessary to spin three crating bolts of the children's chairs in the passenger compartment. After this, back the back of the back seats and remove the fillets and remove the filler.

First, we need to dismantle the state chairs. We need to remove the sleds from the Elange seats and expand the holes under the rack-mounting bolts. Every hole needs to be increased by about half a centimeter.