Vehicle interior

If the clutch is to be adjusted in the Hover with an electronic spread (H2 diesels, H3, H5), it is necessary to keep in mind the following: when the clutch is engaged, it is necessary to switch off the connector of the trailer for the clutch of the clutch.

One of the features of Lifan Solano in the first years of the release is the failure of the air-conditioning heat sink. As a result of the vibrations, it overtures the engine radiator and ends

In the first place, you need to remove the four bolts on the 16 screws that hold the seat, then disconnect the electrical connectors and lift the seat. Then we need to remove the plastic lining of the seat perimeter, which is fixed by self-locking

To remove the ceiling plating in the Hover, it is necessary to remove the handrails over the occupant's heads (each one is secured by two carrots), remove the windows of the lights, then turn off the lights and then unscrew the headphones themselves

One of the features of Lifan Solano is the automatic insertion of air recycling in the passenger compartment. In the conditions of the Russian climate, this leads to very rapid conjecture of glass. There are two ways to solve this problem: 1

There's a lot of oven radiator in the hovers. In order to do this, a partial cleaning of the panel is required. First of all, it is necessary to drain the cooling liquid and detach the main line from the heat sink under the bonnet

For folding of rear seats in universalization Honda Accord 7 Touring: 1) Raise the elbow in the original position. 2) Seat-belt locks are placed in the tabs at the bottom of the seat pan .3)

The comfort indicators in the Liffan Solano salon, calculated by experience, have the following values: Shumness in closed windows and engine on idling speed-about 50 dB. The noise in closed windows and the 3000 rpm engine is about 61 dB.

The most common places of creaking and daneless in the saloon 8 are:-The area of the cup holder. To remove the tree, you need to glue a small metal piece on the lid of a cup holder or seal it with a millimeter's line

There is an SVC function on Honda Accord 8, which changes the volume of the magnet based on the speed of the car. To activate it: 1) Press the MENU key and rotate the switch until SVC.2 is shown on the display) Press ENTER