Car body

Drainage holes contribute to the diversion of water from the vehicle's hidden cavities. In the Focus 2, the drainage holes are located in the lower end of side doors and in the lower end of the back door. The holes must be trimmed with a wand or screwdriver periodically

As a general rule, the front bumper should be removed to install the safety net on the heat sink. However, there is an opportunity to install a grid without dismantling the bumper. The grid needs a small honeycomb to stop even small stones

Due to a defective assembly, the luggage door may hit the bumper and scratch it. To align the position of the door, the lock must be adjusted. Work will require a Torx key (asterisk) on 45

If a Ford Focus of the 1st generation has come to an unsuitability and has stopped cleaning glass properly, they need to be replaced. The replacement should focus primarily on the size of the size of the Ford Focus I wiper

The brush of the rear windscreen wiper on Lada Lurgus is often quickly worn, so many people are looking for an alternative. The code for the original brush order is 7701047871. It is also possible to order a similar brush for the Bosch production, its number is 3397004631.

On the Ford Focus 1, after the activation of the glass washer, the wipers make three breakers and one extra break after a pause. The additional aim is to remove the residue from the top of the cleaning fluid. In fact, the extra blow smears dirt on the clean glass.

The end-of-door protection system for the doors is a mechanism that will put rubber protection on the edge of the door when it is opened and a hiding-rubber band when the door is closed.

Many people are checking the progress of the VAZ-2110 window, taking off the glass and checking without load, but in such a way it will not be possible to determine with certainty whether the window-lift is entirely right or not.

This may be done, but a number of changes and modifications will be necessary. The most difficult is the replacement of the bumper. In the US version, it is twice as wide and as a [ [ longerons]], while in European cars the bumper is mounted on [ [ stiletto]] s

There may be more than one reason. If the washer has ceased to work in the winter (the motor is not heard), then most likely the freezing liquid has been frozen or the fuse is blown