Car body

The most common problems are the rust of chrome metal, the splashing of chromium with plastic elements, and the peeling of the paint on the doors, the pillars of the roof and the lid (door) of the trunk

The isolation of the arke is one of the most uncomplicated stages of complete noise insulation of the car. It is necessary to remove the wheel, splatter and the arches

The dimensions of the driver's and passenger brushes of the windscreen wiper on the VAZ-2108/09/99 are identical. Both sides use a brush with a length of 51 cm. On the driver's side there is an opportunity to put a magnified brush with a length of 53 cm

It's a pair of front bumpers. First, you have to remove the headlights by turning 2 bolts on each. It is then necessary to disconnect the bonnet cable from the handle and release the casing of the cable from the "hook" holding it under the bonnet.

Remove the front bumper to Reno Flüense in this sequence: Raise the front wheels and remove the front wheels. Unwind the front corners. Take off the top air duct 1

It is recommended that the glass in the VAZ-2110 showroom not warm inside in rainy weather, it is recommended to turn on the oven, preferably at a higher power

First, remove the plastic lining inside the upper edge of the rear glass and rotate the three bolts and two screws on each side below it.

There's a sticker on the gas tank with the correct position of the filling gun. The gun must be parallel to the ground. If the pistol is fully omitted in the throat, the safety valve is likely to be actuating

The thresholds have always been the weakness of the VAZ cars. In almost any model (2106, 2107, 2108, 2109, 2110, 2111, 2112, 2113, 2114, etc.), the thresholds are met from not too high-quality metal, and the level of [ [ corrosion]] treatment is often chronicled

The cracks in the windshield area of the windshield may be available for two reasons. Temperature difference: hot air flow on glass in winter or air-conditioned cold air in summer. Glass can crash with a loud cotton.