Car body

Instead of the bonnet subrate, a gas emphasis may be placed. It will be located in the centre of the bonnet. The first thing you need to do is remove the plastic cluces of the inner hood cover by squeeting the retainers

The European and American modifications of the Lexus RX II are not different. To install the boot to the car reels, you need to do the following: Remove the back lining of the raaling that is held by the middle

One indication that the body geometry is not disturbed is the correct clearance between the body panels. They must be equal to Jill MK: Between the front and the sidewall, 2.5 to 3.5 mm, between the front and the front door 4-6 mm

If there is a need to replace the rear bumper to Jill

Instead of the original wiper blade, it is possible to install the Bosch carcasses, the suite number of the two pieces-3 397 118 991. The length of the driver's license is 65 cm, and the passenger side is 60 cm in length. The cost is around 1,000 rubles

In order to remove the front bumper to Jia MK, we will need a 10 key and a flat and Phillips screwdriver. First, remove the plastic lining above the radiator

An AXIOM frontal glass ISUZU 4D UTILITY 2002-05 \ Great Wall Hover Van 2005If a rain sensor is installed on the car, it will have to be replaced with the windshield. It can't be disconnected because it's glued to the windshield.

To set up a spray-suppression system on the Lexus RX 330 II, you must complete the following sequence of steps. Detach the bolt, securing the cover, and the bolt that holds the threshold

It is necessary to remove the railing itself before the rails are removed. The rails are secured by large hex hex bolts. The guide enters this plastic part

The color number can be found on the sticker on the middle rack on the passenger side