Car body

Details

Written by: Jason Hance

Also available:

Created: 09 June 2023

First, you need to remove the rectangular panel with the high-frequency speakers located opposite the rear view mirror in the passenger compartment. The panel's on the clips. There are three Samores under the cover and there is a mirror

Details

Written by: Jason Hance

Also available:

Created: 07 June 2023

To remove the grille of the Kea Serato 2 heat sink, you will need to twist 8 self-ov. The best way to do that is to remove the bumper, and then unscrew the grille. If you remove the bumper, you need to use a flexible-blade screwdriver

Details

Written by: Jason Hance

Also available:

Created: 06 June 2023

In some trim pieces, the Kia Cerato 2 has a cut below the tailpipe at the bottom of the rear bumper

Details

Written by: Jason Hance

Also available:

Created: 04 June 2023

It happens that the warranty Kia Cerato 2 appears to be corrosion-free. The most common locations are about the petrol tank top, the trunk lid, the front racks

Details

Written by: Jason Hance

Also available:

Created: 03 June 2023

Remount the heating of the mirror on the fourth generation Audi of the fourth generation as follows: With a knife separating the plastic and removing the remains of the duct tape. There is a transparent film that is removed from the edge.

Details

Written by: Jason Hance

Also available:

Created: 02 June 2023

A crack at the bottom of the windshield in the VIN-room area, a common problem with Kia Cerato 2. In case there are no external injuries (bevels), the glass is changed under the guarantee

Details

Written by: Jason Hance

Also available:

Created: 02 June 2023

Procedure for removing the front bumper at Audi 100 P4: Remove the lower protection of the engine. Lower inserts of the radiator grille. In the bars on the left and to the right, in a single bolt, open the hood and unwind the bezel underneath the pharaes

Details

Written by: Jason Hance

Also available:

Created: 01 June 2023

Removal of rear bumper at Audi 100 C4: For the car body, the back of the carpet is in the trunk. For a station wagon, we're going to get a shelf in the baggage compartment, and then we're going through the side of the side of the side. We're spinning the left and right side of the trunk with two bolts.

Details

Written by: Jason Hance

Also available:

Created: 01 June 2023

The Kia Cerato 2 windscreen washer conditions are not regulated. Attempting to adjust them will cause a breakdown. Due to the fact that there are no moving elements in Serato Serato 2, the direction of the string never gets lost and they spray where they need to be

Details

Written by: Jason Hance

Also available:

Created: 31 May 2023

To replace a door lock with a door lock at a Aodi 100 P4: Remove the front door handle. The key is inserted so that the locking plates and springs are not dropped when the cylinder is removed. On the rear end of the lock, remove the locking ring. The position of the lock and the elastic element shall be removed