Car body

Body number and vehicle information plate are under the rear of the motor panel on the front passenger side. At the driver's side, the plate is also under the driver's windscreen.

Nissan X-Trail 2 will have a brushes of the following dimensions:-Dvornik driving (left): 600 mm-Dvornik Palace passenger (right): 400 mm-Rear: 350 mm.

Nissan X-Trail 2's back-yard is aesthetic, but it is very short. The glass pane allows you to install a longer courtyard and improve the backward view. Restricts the length of the caretaker only to the top of the glass washer superstructure

To remove the bumper, first remove the grille and the side duvents of the engine compartment, which are located behind the wings and are fastened by the latchs

The Nissan X-Trail 2nd generation has a tug, which will be useful if the vehicle is to be towed. However, it is difficult to detect a towing hook on Nissan X-Trail II and can be difficult to use because the hook is closed

You must do the following to install the security grid on the X-Trail radiator 2. 1. Prepare a grid of appropriate size and 10-15 plastic hinges. 2. Remove the grille. 3. Cut a piece of the grid according to the heat sink dimensions. 4

The normal OP-4 fire extinguishers are very comfortable to be fixed in the boot with specially designed rubber. They're in the trunk on the right side. However, a smaller fire extinguisher (1-3 l) is shorter and will be hung

In order to make the door illuminating, you will need two LEDs on 12 V, an insulated wire, a thermothery tube, a T15x75 screwdriver, and a flat, flat, lighter (remove insulation from wires), duct, scissors

To set the grid to bumper on Astra J GTC, the bumper must be removed. The grid should be fixed on the back of the bumper onto plastic hoses. It is possible to put a longer grid-to close the entire grid. Then we need to set the bumper to the spot.

In order to avoid bending the license plate when the bumper is installed, a special podium can be acquired and attached to the bumper, and the number plate fastened to the bumper