Car body

If the Mitsubishi Outlander Outlander XL is formed in the windshield, it is easy to remove. Such damage can be remedied (smear polymer, proclate, etc.) in any car service that has the service of this profile

I can get Nisha in the trunk with a curtain. A curtain wall for this is to be placed at the bottom of the boot into the same openings as it is mounted (30 cm deep). The curtain itself is fixed as usual

Due to the use of the body design with the integrated frame, Mitsubishi Pachgero's 3rd generation has a high sensitivity to impact and damage

The 4-generation Mitsubishi design is distinguished by a chassis-bearing body with an integrated frame. The body has little or no weaknesses in the form of corrosion centers

To fix the problem with the back porter Mitsubishi Pajero 3, do the following: (1) Carefully remove the lid from the janite.2)

Procedure for removing the front bumper of Mitsubishi 4: 1) Remove the radiator grille and front protective cover of motor 2)) Disconnect the front wheel builder. 3) Remove the front wheel archers. 4) Unwind and remove the screws and retainers

Rear bumper removal procedure for Mitsubishi Fingeros 4: 1) Hind fr. 2)-Remove rear wheel (s) filmlifting. (4) Remove the connectors of the parkthrones.5) Discard the bolts and remove the centre of the bumper in assembly.

The guarantee for Nissan Almera Classic is 12 years old for Nissan Almera Classic. There are many opinions about the galvanizing of the body. Someone thinks the body is galvanic, someone isn't galvanically. Dealers report that they are cynically in "critical locations"

It's very simple to remove the grille. To do this, you need to open the hood, turn off the screwdriver, and click the two clips close to the center of the grille and then squeeze the clamps on the ends of the grille. After that, you can pull the grate on your own and take off

When choosing the protection of the crankcase, it is necessary to pay attention not only to the material it is made from, but also to a number of technical browns.First, the protection must have an opening for discharge of oil. This will allow it to be removed every time the oil is replaced