Car body

Details

Written by: Jason Hance

Also available:

Created: 28 August 2022

Plastic in the body of Mitsubisi Outlander XL is very easy (the cheapest material) is scratched. Plastic panels with vinyl decorative film can be delayed for the purpose of prevention

Details

Written by: Jason Hance

Also available:

Created: 26 August 2022

After the acquisition of Mitsubishi Outlander XL, it is desirable to verify that the decorative lining of the decorative lining of the front fog lamps is correct. If one of them is not properly installed (s), it may take off shortly

Details

Written by: Jason Hance

Also available:

Created: 25 August 2022

It is possible to select the color of the paint (even the code) for the Mitsubishi Outlander's XL body can only be used in a special shop where there is a [ [ computer coloring]]

Details

Written by: Jason Hance

Also available:

Created: 23 August 2022

The technology opening is located along the doorway of the Mitsubishi Outlander XL. Through it, you can have a bonnet in the cabin. There is also an opening with a rubber gasket for an additional transaction

Details

Written by: Jason Hance

Also available:

Created: 21 August 2022

In order for the back yard to work better in the winter, it is necessary to perform the following preventive actions periodically (once in 1-2 weeks). Remove the brush from the car and take it to a warm place to outrou

Details

Written by: Jason Hance

Also available:

Created: 20 August 2022

The mirror folding button at Mitsubishi Outlander XL is pressed to the point (click and release without effort). Therefore, if you press the mirror button, it is better to contact the service

Details

Written by: Jason Hance

Also available:

Created: 18 August 2022

Most of the time, drops appear on the inner surface of the rear window of Mitsubishi Outlander XL. If the drip is a little (one-two), most likely it is the condensate that appears during the rain or when the glass is wruned (the drops are collected at the top of the glass and then run down)

Details

Written by: Jason Hance

Also available:

Created: 16 August 2022

First of all, we need to try and warm the gas tank. It's better to go to the warm parking lot. The lighter is better not to use (still petrol tank). It is also possible to spray the mechanism with a WD-40 aerosol or to lubricate the silicone

Details

Written by: Jason Hance

Also available:

Created: 15 August 2022

There is no heating function after the mirror has been replaced. It is possible that the box was not heated, sometimes. If the heat is present, you need to remove the plate plate (two clips from the bottom) and check the incoming voltage on the contacts. This is done by a tester or a 12V lamp

Details

Written by: Jason Hance

Also available:

Created: 13 August 2022

Many of the owners of the Outlander XL complain that it is difficult to understand the algorithm of work of the rain sensor when it is difficult (it does not work, it does not work on time, etc.). There is even a desire to disable this function and switch to manual control