Car body

Details

Written by: Jason Hance

Also available:

Created: 14 September 2022

The car needs to be carefully washed before the LCP is repaired. For repair, you can use the original set for Mitsubishi. You can purchase it from a dealer. The kit contains two tubes: one with paint and one with varnish

Details

Written by: Jason Hance

Also available:

Created: 12 September 2022

You can try the bumpers on your own. This will require epoxy adhesives (e.g. Poaxiol), construction grid (serpyanka), macar scotch, alcohols and metal mesh. The tools use a soldering-iron, hammer, screwdriver, and a knife

Details

Written by: Jason Hance

Also available:

Created: 10 September 2022

Before we start, we need to carefully clean the interior of the wheel arches, remove the wheel. After removal, it must be carefully washed and beheaded. It is particularly good to process the top of the cover

Details

Written by: Jason Hance

Also available:

Created: 09 September 2022

The ninth generation door plating is held on reusable plastic pitons. It is better to work in warm weather or in a heated room, as the cold is made fragile. requires a front and flat-blade screwdriver

Details

Written by: Jason Hance

Also available:

Created: 07 September 2022

The solution to the problem will require a spray with silicone grease. Then, it is also necessary to lubricate the cable that is suitable for the bonnet opening lever in the passenger compartment.

Details

Written by: Jason Hance

Also available:

Created: 05 September 2022

The bonnet should be set only by 2 stops. Setting the bonnet over time may cause the bonnet or the failure to be misaligned. The lower anchorages are placed in the regular openings, and the holes for the upper anchorages must be checked

Details

Written by: Jason Hance

Also available:

Created: 04 September 2022

We'll need two gas stops. Every effort should not exceed 200 N, so there is no rule "the stronger-the better". The emphasis of Honda Civil III hatchback length of 65 cm in the open state and 42 cm-in the closed state

Details

Written by: Jason Hance

Also available:

Created: 02 September 2022

In a series of the 10th generation of the 10th generation aircraft on the interior of the bonnet, over the headlights, additional rubber gaskets are installed, preventing dirt from entering the subspace

Details

Written by: Jason Hance

Also available:

Created: 31 August 2022

The windshield is thought to be more evenly flushed with the windshield. On the ninth generation Laser trout can be installed from Volvo. Part number-30655605

Details

Written by: Jason Hance

Also available:

Created: 30 August 2022

Often after the installation of a good music system there is a need for vibration-and noise insulation of doors. Once it is installed, the doors will become heavier, and the sound quality of music will be considerably improved