Car body

Options for wipers at Mitsubishi ASX

Options for wipers at Mitsubishi ASX
If the scrubbers of the wiper Mitsubija AFS are out of order and "resuscitate" by their own forces, they need to be replaced. When choosing the caretappers for Mitsubishi ASX, first of all should be oriented to the length of the state brushes

Adjusting the Mitsubishi ASX homing

Adjusting the Mitsubishi ASX homing
The Mitsubishi ASX washer device is adjustable, but it needs to be done with a thick needle and with a lot of effort. The diameter of the needle shall be such as not to extend the nozzle opening

Self-installation of the kapat gas-points at Mitsubishi ASX

Self-installation of the kapat gas-points at Mitsubishi ASX
The gas tank set consists of two shock absorbers, two bonnets for bonnet installation and two for the wing. You will need keys 12 and 13, 6-hedron by 6, and a screwdriver, and the bonnet is mounted in the hinges of the hinges to the hood

Installation of luggage reeling at Mitsubishi ASX

Installation of luggage reeling at Mitsubishi ASX
First of all, we need to remove the black roofs from the roof. After that, we need to carefully and carefully mark the points for drilling. It will be necessary to drill holes in the roof in the gutter where the filler was

Installation of additional Mitsubishi ASX trunk lighting

Installation of additional Mitsubishi ASX trunk lighting
The Mitsubishi ASX trunk coverage is clearly not enough, and the placer is located so that it is often closed. Therefore, it is possible to additionally install LED feed, locking it from wiring of the regular light

Installing the chrome finish of the Mitsubishi ASX radiator grille

Installing the chrome finish of the Mitsubishi ASX radiator grille
To replace the grille fence, you need to remove the bumper, unscrew the old black, which holds 18 carropes. It is important to comply with the order of installation. First, the right and left parts are fixed, and then the top and bottom are fixed.

Installation and noise isolation of the Mitsubishi ASX

Installation and noise isolation of the Mitsubishi ASX
Noise-insulating material shall not be thicker than 3 mm, otherwise the covers will be very difficult to install. It is better to glue the coverings to smaller chunks, as it has a rounded shape, and if you use large snacks, it will form folds

Installing a katte lock with a discovery sensor on Mitsubishi ASX

Installing a katte lock with a discovery sensor on Mitsubishi ASX
The installation will require the chateau with the opening sensor (the sensor is not sold separately) and the key to 10. The hood must open and remove the clips installed on the sides of the radiator grate on the inside

Installation of rear-view mirrors with Mitsubishi ASX Mitsubishi

Installation of rear-view mirrors with Mitsubishi ASX Mitsubishi
The first thing you need to do is twist the bolt in the door to the door, and remove the door cladding, and then pull the cover plate in the corner of the door (the top of the high frequency speaker) and pull it on itself

Replacing the rear court with Mitsubishi ASX

Replacing the rear court with Mitsubishi ASX
Over time, the rear caretaker on Mitsubiša of the ASH is out of order, and the owner of the car has two ways-to try to "resuscitate" the wiper or to replace it immediately