Electrical equipment

Geely MK Diagnostic connector considerations

Geely MK Diagnostic connector considerations
The Geely MK Diagnostic connector is located below the left side panel

LADA Kalina turns on

LADA Kalina turns on
If the turning on the LADA Kalina turns on a long light, the problem is caused by the wear and tear of the engine switch, and is fully resolved by replacing it

Geely MK features

Geely MK features
The Gil MK's parktric works in sound mode and also allows to display information on the display. You can also display other useful information. You can control the switching modes with a and b

Checking the ignition switch on Geely MK

Checking the ignition switch on Geely MK
1. Remove the lower plastic cover under the wheel and push off the ignition locking system. 2. Then, with the help of a tester, call the chain at various keypoints in the lock

LADA Kalina LADY turns on fuse (s)

LADA Kalina LADY turns on fuse (s)
Most often, the fuse in the LADA Kalina is caused by a short circuit which occurs because of the structural peculiarities of the socket of the cigarette lighter

Geely MK engine fuse location

Geely MK engine fuse location
The fuse box in the engine compartment Jill MK is as follows: it contains the following fuses and relays: 1-compressor of air-conditioner (10 A)

Geely MK coil fuse location

Geely MK coil fuse location
The safety of the fuse box is located in the form of the fuse and the relays: 1-air-conditioners (7.5 A. 2)-general power (20 A)

The LADA Kalina LED on the LED lights on the LED lights on LED flashing lights

The LADA Kalina LED on the LED lights on the LED lights on LED flashing lights
When replacing the lamps in the LADA Kalina light, the circuit breakers are burned because of the design of the backplate of the rear registration plate, namely, at the location of the terminals

Replacing the Geely MK Lamps

Replacing the Geely MK Lamps
In the front fog lamp, GIMU's lamps are changing so: unwind the front or the driving beam's cap counterclockwise, and remove the spring retainer on the reflector.

zeroing of ECU on Great Wall Hover

zeroing of ECU on Great Wall Hover
It's quite simple to reset the control unit in the Hover. It is necessary to heat the engine, turn on the dipped-beam headlamps and front fog lamps, shut off the engine, without turning off the headlamps and the anti-mists