- Details
-
November 22, 2022
-
Written by Jason Hance
Headlamps on Honda Akcord 7:-Main-beam headlamps HB3 60 W-Dipped-beam headlamps-HB4 55 W (halogen) or HID 35 W (xenon).-Fog headlamps 55 W-Front and rear direction indicators-21 W-Front position lamps-5 W
- Details
-
November 21, 2022
-
Written by Jason Hance
On the VAZ-2110 voltage is checked at the terminals of the JSCB, but it is better to start the test from the measurement of the voltage when the engine is plugged. It is necessary to connect the voltmeter to the cells of the [ [ KB]] and remember the value that will give the device
- Details
-
November 21, 2022
-
Written by Jason Hance
The sensors of the parktronic to the Honda Axd 8 work as follows: 1) Side gauge:-At a distance of 45 to 60 cm, the left or right indicator is continuously lit and the sound signal is heard (high frequency)
- Details
-
November 20, 2022
-
Written by Jason Hance
There are several interesting settings in the Honda Cord 7 tape recorder: (1) Push the Power button and turn on the magnetization button. Press and hold the Power button for about 5 seconds. The magnet is fused and will appear on a menu in which only horizontal buttons with numbers are available
- Details
-
November 20, 2022
-
Written by Jason Hance
The Borth computer (BC) performs a large number of important functions, so choosing one should be guided by the characteristics that you need most
- Details
-
November 20, 2022
-
Written by Jason Hance
To remove the permanent magnet on the chord 7, you need to do the following: 1) Remove the top finishing trim panel 2) Disconnect the two connectors and the antenna mashe.3) Remove the three thumbscrews from the top of the magnet and three of the thumbscrews (4) Remove the magnet control panel and the air-conditioner
- Details
-
November 19, 2022
-
Written by Jason Hance
To replace the xenon-new lamps of the main light: (1) To dry up the hands before the start of work.) Turn the lighting switch to the position of OFF.3) Disconnect first "minutes" and then "plush" wire from accumulators .4) Remove the JSCB
- Details
-
November 19, 2022
-
Written by Jason Hance
Many of the owners of VAZ-2108/09/99 experience discomfort due to the lack of automatic switching off of the passing beam. On the VAZ-2108/09/99, it is possible to install a system that shortly after the ignition of the vehicle will extinguize the dipped-beam and the position lamps.
- Details
-
November 19, 2022
-
Written by Jason Hance
To test the power of the mirrors on the Honda Civil 8: Unmount the driver's door panel. Disconnect the "3R"/"6R"/"8R" connector from the rear-view mirror. Check the operation of the actuator by joining the power and the "mass"
- Details
-
November 18, 2022
-
Written by Jason Hance
To check and replace the lights of the original box on the Honda Civil ivic: Open a web-box and unplug the slot "2P".