- Details
-
December 13, 2022
-
Written by Jason Hance
For early-release vehicles, Bosch headlamps were installed with glazing (marking AL), whereas the headlamps of the Kirzhać glass were replaced by polycarbonate. There is no free sale of belts for polycarbonate headlamps. Therefore, the replacement glass can only be purchased for the Bosch headlamps
- Details
-
December 12, 2022
-
Written by Jason Hance
To program the automatic door locking program at the beginning of the Ford Mondeo III car, it is necessary to hold the ignition switch in position "II" without starting the engine.
- Details
-
December 12, 2022
-
Written by Jason Hance
If all three stop lamps stop working at the same time, the problem is most likely in the stop lamps switch. It is located on the foot of the brake pedal bearings
- Details
-
December 11, 2022
-
Written by Jason Hance
This is usually caused by a breakdown of the reversing lamp. It is fitted to the ACPR body, adjacent to the lock on the back of the back gear, on the side of the left hand. Replace: 1. Unprotect the engine crankcase; 2. Detach from breaker switch; 3
- Details
-
December 11, 2022
-
Written by Jason Hance
In Mondeo 3 the audible signal is located at the front of the splash. The dynamic itself is perfectly protected from moisture and dirt, so its failure is most likely due to a problem with the transaction. But the contact may be broken not only in the bowels of the engine compartment, but also in the steering wheel
- Details
-
December 10, 2022
-
Written by Jason Hance
It is possible to manually regulate the delay of the mondeaux to Mondeo. On the machines equipped with the rain sensor, the frequency of the frequency depends on the speed of the motion. The higher the speed, the more often the windshield wiper triggers
- Details
-
December 10, 2022
-
Written by Jason Hance
To begin, check the safety of the fuse in the F6 side of the block. However, most often the signal is refused due to the [ [ membrane]] of [ [ membrane]], because dirt and dust are covered in the shell
- Details
-
December 10, 2022
-
Written by Jason Hance
There are several ways to control the operation of the reversing sensor on the Ford Mondeo III: Remove the JSCB and air filter. Next disconnect the connector, unplug the sensor, turn on the rear
- Details
-
December 09, 2022
-
Written by Jason Hance
If the Ford Mondeo III pump does not pump the liquid out of the bacht, it is likely the problem in the oxidized contacts of the bow switch. To access the right-click switch, the steering wheel has to open the cover (the cover) by pressing the two fastening clips
- Details
-
December 09, 2022
-
Written by Jason Hance
The fuse in the F5 key is also responsible for the SD control unit, but it is most likely to burn because of the heater fan