Car body

Details

Written by: Jason Hance

Also available:

Created: 16 April 2023

The radiator mesh on the Chevrolet C100 C100 has large cells. Therefore, an additional grid can be installed to protect it from damage and pollution. For this: (1) Headlamps, bumper and three bars

Details

Written by: Jason Hance

Also available:

Created: 15 April 2023

To put an additional protective net on the grill of the Chevrolet C140, perform the following: (1) Unwind bamper.2) Take off front fog lamps and hose from the headlight washer, prefilling the liquid drain capacity

Details

Written by: Jason Hance

Also available:

Created: 15 April 2023

In Sportage III of the domestic assembly, there are gaps in corrosion protection, namely, at the rear of the silencer, on the bottom of the silencer, on the bottom of the silencer, in the rear-springs area and a large number of separate passes

Details

Written by: Jason Hance

Also available:

Created: 14 April 2023

The experience of the operation of Chevrolet Captiva in Russian conditions revealed a number of weaknesses in the body, where corrosion is possible: 1) Angles of nickel lining on the doors of the boot. Rust here may appear in several months of operation during mileage distances of 20,000 people. km

Details

Written by: Jason Hance

Also available:

Created: 14 April 2023

The removal of the rear bumper at Chevrolet Cobalt is made in this sequence: (1) Hind tail 2) Disconnecting rear covers from bamperate.3) Take off the vehicle by taking off the piles of the left and right edge of the bumper to the body

Details

Written by: Jason Hance

Also available:

Created: 13 April 2023

This is one of the typical problems for the Kia Sportage III of the domestic assembly. The problem is that the filler of the upholstery screw seal has three fastenings of the back door, which means that the latter is very quickly wiped out

Details

Written by: Jason Hance

Also available:

Created: 13 April 2023

Informative plates on the Chevrolet Cobalt are located: The tablet with general information about the car is located at the bottom of the front passenger door frame. It contains the VIN number, pick code, body dye, and mass characteristics of the car

Details

Written by: Jason Hance

Also available:

Created: 12 April 2023

To disassemble the exterior mirror at Chevrolet Cobalt: (1) Rotate the mirror (reflecting the element) to the attention of the way.2) Teach the reflecting element on itself and remove it from the corpuls3)

Details

Written by: Jason Hance

Also available:

Created: 12 April 2023

If you find small bubbles underneath the paint, it's better to immediately repaint the entire detail. Because after the wash, these bubbles can be formed in the size of the stains, and later rust can be rust

Details

Written by: Jason Hance

Also available:

Created: 11 April 2023

In order to install a spray-suppression system at Chevrolet Cobalt, you will need a T-20 SARS screwdriver and a large diameter or drill. Let' s get the rudder in this sequence: (1) Unwind the rudder on the side of the sprayproof