Car body

Third-generation CR-V wipers are criticized by almost all owners of the model. In some cases, after a few weeks since the start of the new car, the windshield wipers begin to leave untreated areas on the windshield, the divorce, etc

The rear bumper of the first generation of the first generation of Mazda is easier than the front, but the rear lamps will also have to be removed. The entire process takes an average of half an hour

Many owners of Honda CR-V III noted the appearance of strange body creaks on cars with mileage. The problem lies in the beetle panels, which, due to the low rigidity of the welding, can be terraced to each other

A Stuk in the central frame is based on the front door of Honda CR-V III. It is easy to solve it-it is necessary to open the door, to find the door in the castle area with a rubber bandit and turn it on a quarter or on the floor-turn

The windshield washer in Mazda 6, the first generation, is quite fragile and easily broken by adjustment. Each nozzle is divided into two parts, each with two nozziples. The centre of each half of the nozzle has a projection

To insert a protection grid in front of the grille of the Honda CR-V III, it is necessary to remove the bumper from the anchorages-multiple plastic clips. To do this, you need to get the central part of the clip, pull it up, and then pull out the clip completely.

Due to the structural peculiarities of the trunk door opening, the dirty water accumulated after the rain is poured over the driver's head. This design disadvantage of Honda CR-V III can be removed by installing a special rubber lining to prevent water from falling

The nozzle of the windshield washer on Mazda 6 is often muddled, and their settings are often confused, and when they try to regulate them, they can easily break

In a third generation CR-V salon, when moving at speeds above 100 km/h, there may be a noise coming from the windshield. The reason is often caused by the appearance of a gap between the [ [ windshield]] and the [ [ roof fixing stripes]] on the roof

This situation is one of Honda Fit's cuckolies. The lag in the trunk appears due to the cracks in the roof of the roof to the walls of the body. The cracks are caused by the bad roads, the car's body is deformed, which makes the stitches out