The procedure for replacing the coolant with the Honda Axord 7 is as follows:
1) Wait for the engine to cool, turn the key to the ON position, put the heater regulators or the air conditioner on the maximum heating and remove the ignition switch.
(2) The radiator filler cap shall be removed.
3) Put the capacity under the heat sink and lift the drain crane.
4) Unwind the expandable tank, pour the OJ from it and put the tank in place.
(5) Fill a new liquid into the radiator to the base of the filler neck.
(6) Start the engine for 30 seconds and damnit it. We're looking at the level of oJ and we do it if we need to.
(7) To extend the OJ to an expansion tank to the MAX mark.
8) End the radiator and the beachchka plug.
(9) Preheat the engine to the operating temperature and dampness it.
(10) Check the level of the OJ in the beachchet and radiator and, if necessary.