Transmission

There are several possible causes of problems with the adaptation of the box Izitronics to the Opel Vektra C:-Development of gear selector. Usually accompanied by error P1732. In this case, you need to replace the wornout parts.

Operate Opel Vetra C with a box of EasyTronic needs to stick to certain rules:-When stopping for more than a minute, switch the lever to neutral.

The Opel Vektra C automatic boxes are rather problematic. Failure to do so is often the case with the ATCP control unit and has to be reprogrammed. There may also be a breakup of the gross boxes.

All the manual gearboxes on the Opel Vectra V are versions of one 5-step aggregate. It was also equipped with an automatic 4-speed box. Mechanical boxes are very reliable and do not have any weak points, except for the leak of the salamist

The adjustment of the transmission of the mechanical transmission to the Opel Vector B shall be carried out in the following sequence: 1) A lighting nut bolt, which attaches the rod-switch gear rod

To adjust the transmission of the IBC to the Opel Vektra C: (1) Remove the plastic frame and release the lever on top 2)

Procedure to replace the oil in the automatic box Opel Vektra C: 1) Install the car on a flat ground and bet on the engine .2) When the engine is running, press the brake and switch the selector lever over all ranges. (3) Stretting lever in position P

The reason for the fact that Peugeot 206 has ceased to be transferred to the Peugeot 206 is the gearshift gears. As a result of wear, the bolt can be broken by which the fox is attached to the box

The automatic gearbox installed on Peugeot 206 has three modes of operation: economy, sport, and winter. The economy is a standard mode in which transmission operates at small speeds. This saves fuel

The most common cause of the fall in the fluid level in the Peugeot 206 automatic transmission is the leakproofness of the power train on the left side. The dashboard must flash two LEDs at the same time