Wheeldrive is a very popular tunning object by car owners. Someone's going to go further and someone goes further and thinks about lighting the wheels of wheels. The more so, that it is not so difficult to make wheel discs with their hands.
Light-emitting diode (LED) tapes are most commonly used to highlight drives, as they are easy to install. You can buy four separate LED pipes or a complete set of disks for sale in auto shops. In addition, the work will require wiring, fuses, wire, wire, sealant or polymer glue.
The following steps are used to attach and attach a disk drive highlight:
1. Lift the car, remove the wheel.
2. Carefully clean and displace the skin of the brake disc.
3. "Rewind" and consolidate the LED ribbon above the skin of the brake disc. Note that the number of LEDs should be a multiple of three.
4. The cutting of the cut tape shall be treated with a seal or polymer glue.
5. A wire is attached to the LED tape and the connection shall be isolated.
6. The transaction shall be placed in a corrugated tube.
7. The same procedures are followed with all other wheels.
You can have more than one disk drive highlight attachment. You can wire each wire to a single stabilizer and then power the battery, or you can power it from the headlights, the lighter lens, or other devices.
Another flavor of disc illumination is gaining popularity-wireless backlighting of wheel drives. Its advantage is that it does not need to be connected but is powered by solar panels. Wireless illumination of the disks is included only in the dark time of the day and only when the car is moving.
