Engine

Actual fuel consumption Mitsubishi Lancer X

Actual fuel consumption Mitsubishi Lancer X
The manufacturer's declared fuel consumption of the 10th generation of Mitsubiša is not always true. According to the experience of Mitsubishi Lancer X, it is possible to display the data on the real consumption of gasoline in different modes

throttle control of the throttle control of Mitsubishi Lancer 9

throttle control of the throttle control of Mitsubishi Lancer 9
To adjust the lancer throttle, only the key is required to check whether the throttle control is fully opened and the tube is removed from the throttle

Mitsubishi Lancer X

Mitsubishi Lancer X
In the first place, it is necessary to remove and dismount the crankcase protection if it is installed without a luchka for the discharge of oil. After that, it is necessary to remove the bolt bolt and drain the oil into the pre-prepared capacity of at least 5 litres

Mitsubishi Lancer X

Mitsubishi Lancer X
The reason for the click is the cooling system. The exhaust system of the exhaust system is made of thin sheet metal, which is extended during heating and is reduced by cooling. That's why you can hear the click. They are most visible in the new car

Removing catalysts at Mitsubishi Lancer 9 with a 2-liter engine

Removing catalysts at Mitsubishi Lancer 9 with a 2-liter engine
Catalyst is expensive, so instead of replacing them, many prefer simply to remove them. It takes a little time and a crowbar to remove the catalysts. The work needs to be carried out in the "pit" or on a forklift

Lambda probe installation at Mitsubishi Lancer X

Lambda probe installation at Mitsubishi Lancer X
The catalyst is expensive, and in the event of its failure, many of them are simply removed. However, after removal of the catalyst, the check lamp "Check Engine" shall be lit. The simplest solution is to install a NDR under a lambda.

Replacement of motor oil with Mitsubishi Lancer 9

Replacement of motor oil with Mitsubishi Lancer 9
To replace the ninth generation of lancer oil, you will have to perform a few simple steps. In the first place, you need to warm the engine up to a working temperature of 80 to 90 degrees. Then we need to roll the top of the oil filler under the hood.

Replacing the flask on the Mitsubishi Lancer 9

Replacing the flask on the Mitsubishi Lancer 9
You must remove the RMM belt before you start. Then we need to remove the wheel shaft and the cap of the wheel. Using a flat-blade screwdriver, you need to remove the old sausage setting, clean the seedlings, and install a new garden

Reputation of the distribution shaft to Mitsubishi Lancer 9

Reputation of the distribution shaft to Mitsubishi Lancer 9
The first thing to do is to remove the hinged equipment and the EMG belt. Then, loosening the tightening bolt of the gear shaft gears. This will require an assistant to enable the transmission, press and hold the brake pedal

Replacement of spark plugs at Mitsubishi Lancer X

Replacement of spark plugs at Mitsubishi Lancer X
In accordance with the regulations of maintenance, every 30,000 people need to change the spark plugs on Lancery. kilometres of mileage. For engine 1.5, iridium candles are needed, for 1.8 and 2.0 basic candles.