Engine

The heat is not found, but antifreeze goes away somewhere. The level of antifreeze can be reduced by climate control. It's okay. But there are other reasons, more serious. If the salon senses the smell of antifreeze, we need to check the stove.

The smell is getting worse on the hot car. It is recommended to examine possible areas of gasoline leaks. There may be cracks in the weld seams of the catalyst and the suitable pipes.

Most Porsche cars have the ability to read information about failures and faults of systems through the onboard computer, without special equipment

A temperature sensor, Reno Duster, can show between 4 and 6 ticks, and the temperature of the coolant does not actually change. The problem is related to the temperature sensor of the coolant. His replacement usually solves the problem

Some of the Dsters may not have the filter element itself in the fuel filter body. Previously, the fuel filter was installed from the outside, just in that case, it is now embedded in the fuel pump

The undisputed advantage of diesel Duster is low fuel consumption-from 5 to 8 liters per "hundred". It's also a diesel. It gives 200 Nm torque already on 1700 rpm

The candles installed at Duster at the factory are marked with the marking of the Champi RC87YCL.The clearance between the electrodes is 0.95 + /-0.05 mm Force of 25-30 Nm. The key for the candle is at 16. First, disconnect the connector from the ignition coil

First, remove the air filter cover, remove the old dirty filter, and remove the debris from the crust. In no case may the debris be thrown into the hole of the crust, in which case it will be directly into the engine

A stool in the rear of the bottom of Duster was summoned, most likely, to a poorly-docked heat shield of the resonator. We need to check it and, if necessary, pull the rack-mounting bolts. After that, the chasm must be gone.

The leakproofness of the valve cap on Reno Duster is a known problem. First, there are traces of "oil-warming" around the cover, and over time the oil loss increases. The bolts of the valve cover can only solve the problem for a short time