- Details
-
April 09, 2022
-
Written by Jason Hance
The candles on Logan are Champion RYCLC87 or Sagem RFN58LZ, with a gap between electrodes equal to 0.95 ± 0.05 mm. They can be changed, both original and similar, by candlelight
- Details
-
April 08, 2022
-
Written by Jason Hance
The manufacturer does not provide accurate information about Reno Logan's engine resource. Based on the experience of driving Russian drivers, including taxi services, it is possible to conclude about the large resource of the Logan engine
- Details
-
April 07, 2022
-
Written by Jason Hance
According to passport data, the maximum speed of Reno Logan is 162 \ km/h for cars with an engine of 1.4 litres and 175 km/h for motor vehicles of 1.6 litres
- Details
-
April 06, 2022
-
Written by Jason Hance
Official dealer Reno's service representative recommends the use of unleaded petrol with octane number 92, 95 and 98
- Details
-
April 05, 2022
-
Written by Jason Hance
You can pour oil to the top of the probe. From the manufacturer, Logan's manufacturers were generally full-loaded, as it is necessary for the period of the engine. At the same time, we need to be careful when replacing oil so that it doesn't get too much
- Details
-
April 04, 2022
-
Written by Jason Hance
A 1.6 litre engine was used at Reno Logan. Originally an 8-valve motor, which was almost identical to 1.4-litre. Therefore, if necessary, replace the engine and 1.4, and the 1.6-liter engines are practically interchangeable
- Details
-
April 03, 2022
-
Written by Jason Hance
One of the most common causes is poor control of the valve actuator. If all the gaps are in order, other failure of the vent shall be inspected, such as subsidence, springs or valve wear.
- Details
-
April 02, 2022
-
Written by Jason Hance
Reno Logan's producer is elevated to an oil consumption of more than 0.5 litres per 1,000 kilometres. The most common reason for the increased flow rate is the flow of oil through the gross, gaskets, oil filter and oil pressure sensor
- Details
-
April 01, 2022
-
Written by Jason Hance
If a lamp of low oil pressure has caught on the panel, it shall be necessary first to check the engine oil level with the probe
- Details
-
March 31, 2022
-
Written by Jason Hance
Usually, the reason for the starter's work is the wear and tear of the starter's gear and/or the flywheel venom. In this case, when the engine is started, the metal crunchism is heard. Also, the reason for such a crunchet may be a failure of the retractor