- Details
-
January 25, 2022
-
Written by Jason Hance
Replacement of brake pads and discs on the Opel Vectra B in this sequence: (1) Lift the vehicle and take off the wheel 2)
- Details
-
January 22, 2022
-
Written by Jason Hance
To replace the cable of the parking brake on the Opel Vector B, you must do the following: (1) Put the car on the hole and turn on the apron. 2) Take the car off-3) Remove the silencer.
- Details
-
January 19, 2022
-
Written by Jason Hance
To replace the rear brake pads on the Opel Vektra C: 1) Pull over to the car and take off the support.2 3) Remove the rubber rails of the guide fingers and turn them off to the 6-hedron "by 7"
- Details
-
January 15, 2022
-
Written by Jason Hance
One of the characteristic malfunctions of the Peugeot 206 braking system is the acidity of the brake cylinders. This usually occurs after a long car park in a cold time of year. The ashes of the cylinders do not allow the wheels to rotate freely
- Details
-
January 12, 2022
-
Written by Jason Hance
The Peugeot 206 is caused by a lack of dirt-shields on the Peugeot 206. For this reason water with mud gets on the pad during the rain or when the puddle is passing. After a long parking lot, the beads and disks may rusty for the same reason
- Details
-
January 09, 2022
-
Written by Jason Hance
The sound of the brake pedal in Peugeot 206 is connected to the cuff of the vacuum amplifier
- Details
-
January 05, 2022
-
Written by Jason Hance
The most common fluid from the Peugeot 206 hydroamplifier stems from the weakening of the hamts which are attached to the brackets. There is a problem with the installation of additional hamps or regular checking of already existing
- Details
-
January 02, 2022
-
Written by Jason Hance
The sound may be generated by the ABS (antilock system). Her work is also felt by the impact of the brake pedal. When the car is in the heat, the pedal begins to squeal. Within a short period of time, the sound disappears
- Details
-
December 30, 2021
-
Written by Jason Hance
If a squeaking is given during braking, the problem is most likely in the brake pads. They need to be checked and, if necessary, replaced. New beads can creak, but after a small mileage, the creak stops. Also, the creak will be heard if you do not press on the brake
- Details
-
December 26, 2021
-
Written by Jason Hance
The problems with the braking system Reno Logan may be different. Most often, the owners complain about the squeals under braking. Its main reason is the worn brake pads or the use of non-qualified brake pads