Brake system

Details

Written by: Jason Hance

Also available:

Created: 23 December 2021

We need to check the brake fluid level first. If it's near the MAX mark, the pear needs to drain the liquid a bit. Then we remove the front wheel. The piston of the wheel cylinder with the screwdriver, move deep inside the cylinder

Details

Written by: Jason Hance

Also available:

Created: 20 December 2021

The manual brake on the Renault Sandero must be adjusted so that it holds a 25% gradient when the handle is raised by 5 to 7 clicks. To adjust the handbrake, remove the cover of the floor tunnel and remove the stub of the adjustment node (front of the handbrake)

Details

Written by: Jason Hance

Also available:

Created: 16 December 2021

The free brake pedal pedal shall be between 8 and 10 mm. To measure it, you must set the ruler perpendicular to the floor and then press the hand on the pedal until the pressed

Details

Written by: Jason Hance

Also available:

Created: 13 December 2021

The [ [ Renault Sandero]] is not necessarily related to braking problems

Details

Written by: Jason Hance

Also available:

Created: 10 December 2021

The front brake pads on Renault Sandero need to be changed in the bundle-both the right and the left side. Before you replace, you need to drain the fluid out of the brake bar so that it is on the middle level

Details

Written by: Jason Hance

Also available:

Created: 06 December 2021

To replace the rear brake pads on Skoda Yeti you need to lift the car with a jack and lift the wheel

Details

Written by: Jason Hance

Also available:

Created: 03 December 2021

In order to remove the rear brake drum, lift the rear wheel of the rear wheel of Suzuki Grand Vitara II, put emphasis on the front and remove the rear wheel. Take the car off the handbrake. Ruggle out the nut of the handbrake

Details

Written by: Jason Hance

Also available:

Created: 30 November 2021

In order to replace the front shoes on Suzuki Grand Vitara II, a car should be raised by a jacks and placed near the rear wheel, after removal of the front wheel. Scroll down the two screws of the sub-port and remove the subport. Remove old pads, plates, and bolts

Details

Written by: Jason Hance

Also available:

Created: 26 November 2021

A common problem with Toyota Avensis is the error of "Check the manual brake". The problem can be caused by the problem with the parking brake firmware problem. Eliminates by rewriting or replacing the entire block

Details

Written by: Jason Hance

Also available:

Created: 23 November 2021

Replacing the rear brake pads on Toyota Avensis 3 in this sequence: Open the expansion-box cover. During the installation of new pads, you need to watch regularly at the fluid level and, if necessary, to drain the excess