- Details
-
May 18, 2022
-
Written by Jason Hance
The ABS sensor on Mitsubishi Padero 4 is released as follows: 1) Disconnect the three retainers and unwind the two mounting bolts (2) by connecting the sensor connector. 3). However, it is important to be careful with its serrated surface and a pole
- Details
-
May 11, 2022
-
Written by Jason Hance
There are several ways to lift the manual brake. The first one is not required to be parsed. It is necessary to push the brake pedal strongly (on the car) and lift the brake lever several times. If this is not the case, a lift or a pit is needed
- Details
-
May 05, 2022
-
Written by Jason Hance
To replace the right brake disc, the right wheel must be twisted as far as right, and left-to-left. Then we need to unscrew the bolts, the retaining retention bolts, and through the special opening on the back end of the pad
- Details
-
April 28, 2022
-
Written by Jason Hance
Before you start, you need to lift the rear of the car and remove the rear wheels. You must then do the following: 1. Pin wheel brake disc drive 2. Remove the fuse unit cover from central console 3
- Details
-
April 21, 2022
-
Written by Jason Hance
Check of brake pads and discs-every 30,000 km of mileage or 24 months (in difficult conditions of operation-dust, towing of trailer, frequent mountain traffic, etc. -inspection is carried out for every 7,500 people. km or 6 months)
- Details
-
April 15, 2022
-
Written by Jason Hance
If a [ [ Nissan Tana]] has a steering wheel, the case may be in a bad combination of too tight brake pads with regular soft brake discs
- Details
-
April 08, 2022
-
Written by Jason Hance
The reason for this sound is a low-quality friction mixture. As a result of its use, the brake discs and hub are greatly heated
- Details
-
April 01, 2022
-
Written by Jason Hance
First of all you need to remove the wheel, clean up the dirt and rust two rail-bolt guides and remove them. Then we need to remove the piston and clean it from the hardened mud. The piston dust is likely to be done, and it will be very difficult to pack it properly
- Details
-
March 26, 2022
-
Written by Jason Hance
Before painting the brake sub-port in Opel Astra J, it is necessary to remove the wheel, clear and degreasing the surface of the sub-port, close the brake disc and pad with newspaper or polyethylene and paint several layers of paint
- Details
-
March 19, 2022
-
Written by Jason Hance
The free hand of the hand brake is quite simply adjustable. To do this, remove the skin of the lever, pulling it from the edge and pulling it onto itself. A special petal is located in the levers of the lever