Engine

Turbotors tend to consume more oil than atmospheric engines. The Yeta Operating Guide allows for the oil consumption up to 500 ml per 1000 km. mileage

The coolant expansion unit (hereafter referred to as AW) is in the engine compartment. Turn off the engine and let it cool. Open the hood and check the level of the OJ in the expansion bacht. The WAN level must be between "B" (MIN) and "A" (MAX)

The cause of the rookie at the launch of the engine on Yeti is usually a stretch of the GRM chain. One of the reasons is the failure of the video clip of the GRM. The most common problem occurs at a distance of 20,000 to 50,000 kilometers

Some owners of Yeti pay attention to the slight "shooting" at idling speed. Frication of the rubber hose on the expansion tank of the cooling fluid

To replace the heat sink on the Skoda Yetti: Open the hood and remove the air intakes. Then unplug the hoses and the connector to the heat sink fans located at the bottom of the vehicle. Then unplug the fans panel by unscrewing the four side-lines along its perimeter

Yeti's air filter is under the hood of a plastic box. The cover cover is fasteted by 4 screws. The air filter is under the cover. It is attached to the corouac on one screw that needs to be rebolted

The main reason for the bad start of the hot diesel is the malfunctioning of the nozzles of the nozzles that result in an overheating of the fuel to the back. This leads to a critical drop in the pressure of the fuel, and the nozzle does not produce injection

Diesel engine triage can occur for three main reasons: failure of the valve of one of the nozzles; Fuel system or fuel line airline, loss of electrical contact on the cell in one of the fuel injectors

The engines of SsangYong SUVs are installed on three poles-two on the right and left side of the engine approximately at its centre of gravity, one in the rear. Side supports are mounted on the longitudinal frame through rubbed cushions

The automatic tenor of the belt, which consists of a tension roller and a hydraulic shock absorber, is used in the car assembly