Engine

Details

Written by: Jason Hance

Also available:

Created: 18 January 2022

In order to dismantle the TDDs, first of all, the belt and automatic tenets of the belt, as well as the two adjacent pulle' s of the water pump and the fan, must be removed

Details

Written by: Jason Hance

Also available:

Created: 18 January 2022

To dismantle the trout, it is necessary to use a special tool, without which it is not even worth to take. The tool is needed to pull the nozzle out of the well.

Details

Written by: Jason Hance

Also available:

Created: 17 January 2022

The replacement of the antifreeze (coolant) is carried out in several steps: 1.      Heat and shut down the engine; 2.      Open the expansion cover to reset the system pressure; 3.      To take the antifreeze over the cork at the bottom of the heat sink; 4

Details

Written by: Jason Hance

Also available:

Created: 17 January 2022

The typhoon is located on the left side of the engine, it is necessary to remove the measuring probe and disconnect the EGR system in order to gain access to its head. The tithead is used for "27"

Details

Written by: Jason Hance

Also available:

Created: 16 January 2022

To dismantle and install the filament light on the diesel engine, a long head under the M10 nut has to be used. Also, the replacement shall only be done by using the chassis dynamometer.

Details

Written by: Jason Hance

Also available:

Created: 16 January 2022

The pear pump, which is connected to the fuel filter, is used for cold weather, after discharge of water from the filter and in other situations. It is made of rubber, so the pear pump is gradually solidifies

Details

Written by: Jason Hance

Also available:

Created: 15 January 2022

In some gasoline engines, G23D was installed a [ [ release collector]] with a design deficiency due to thermal stresses and vibration caused by the failure of the fastening bracket

Details

Written by: Jason Hance

Also available:

Created: 15 January 2022

The 3th injectors of the fuel tube are one of the characteristic features of D20DT diesel engine. The malfunction occurs because of the design of the tube, but it is not possible to replace it with other parameters-it will change the engine operation

Details

Written by: Jason Hance

Also available:

Created: 14 January 2022

The auto-owner is in a position to evaluate the turbocharger operation as follows. Do not remove the turbine, but only detach the snail up from the snail, examine the blade

Details

Written by: Jason Hance

Also available:

Created: 14 January 2022

The water indicator in the filter shall be triggered when the water collection capacity is filled fully. In this case, remove the water from the filter: 1. Substitue the reservoir for collecting water; 2