The replacement of the rear shock absorbers on the Aodi 100 4th generation (the front-end versions without a road crash adjustment system) shall be performed as follows: Lift the wheel and lift the wheel to the rear axle and lift it by approximately 10 mm. The lower rack of the cushioning rack. Holding the rack at the bottom of the rack, loosing the three top bolts, removing the rack cabinet in the assembly. As a VAG installation pattern is required to disassemble the rack and replace the shock absorber, it is better to entrust this work to a specialized auto service. Lower the lower anchorage (but shall not delay), then lift the rear axle and tighten the upper anchorage bolts of 25 Nm. After that, lower the car on all the wheels and tighten the lower bolt by 95 Nm.
- Lift the car and take the wheel off.
- Put the anvil on the rear axle and lift it by about 10 mm.
- The lower bolt of the depreciation rack.
- Stick to the rack, looser three top bolts.
- We're taking the stand.
- As a VAG installation pattern is required to disassemble the rack and replace the shock absorber, it is better to entrust this work to a specialized auto service.
- I'm going to install the counter in the assembly. Lower the lower anchorage (but shall not delay), then lift the rear axle and tighten the upper anchorage bolts of 25 Nm. After that, lower the car on all the wheels and tighten the lower bolt by 95 Nm.
