In order to remove the introduction of the INCD on Mazda 3 (I) it is necessary to: Remove the brake mechanism and the brake disc. Remove the bar joint at the tip of the steering gear and the stabilizer bar. Next, remove the hinge pin, remove the front bottom lever (rear end), and then lift the front bottom lever (front).Install the spare nut on the drive shaft and hit the nut with the hammer, then separate the wheel drive shaft from the steering wheel. Next, install a special device to hold the semiaxial gear. After the installation, measure the outer diameter, which must be 31.2 mm maximum. If the norm is exceeded, repeat the installation using the new clip. Then put the wheel drive wheel drive, and place the transmissive oil on the working edge Seal and securely lock the drive shaft into the PMP.Further installation in reverse order.
- The oil from the checkpoint.
- Then, remove the braking mechanism and the brake disc.
- Remove the tip of the tip of the steering gear and the stabilizer bar.
- Next, unscrew the mounting bolts, remove the front bottom lever pivot (rear end) and then lift the front bottom lever (front).
- Install the spare nut on the drive shaft and hit the nut with the hammer, then separate the drive shaft from the wheel hub.
- Detach the left wheel drive from the PPC with the lever.
- Next, install a special device to hold the semiaxial gear.
- Before you install, put the new clip up with the new clip.
- After installation, measure the outer diameter of 31.2 mm maximum.
- If the rule is exceeded, repeat the installation using the new clip.
- Then, insert the drive wheel drive into the wheel hub, make the transmissive oil on the working edge of the lock and securely lock the drive shaft to the checkpoint.
- Perform further installation in reverse order.
