Engine

The first generation of BMW was installed on 2 different diesel engines with a volume of 2 litres. Their features are: Motor 120d. Power of 163 hp and maximum torque 340 Nm

In order to replace the candlelight on the diesel Kiia Sorento 2, it is necessary to do the following: 1. Fall-back of the hinged assemblies (by using the key to rotate the stud bolts, remove the belt from the pulley of the generator) .2

The first generation of BMW engines consists of 4 petrol and two diesel engines. They are highly reliable with timely and quality service

The first generation of BMW 1 is considered to be a flow of about 250 grams per 1,000 km. At the same time, some owners faced higher oil consumption-up to 1 L/1000 km. Statistics on such cases show that the problem is about 5-10% of cars

There is no one-digit answer to the question. Much of the life of the engine depends on the timely maintenance and operation of the engine. Most KIA Sorento II owners agree that the car will be without major repairs

To remove the fuel injectors at BMW 1, we do the following: Turn off the ignition and remove the plastic cover of the engine. Disconnect the crankcase ventilation system. Disconnect the nuts and screws, raise the distribution line

We take the first generation BMW generator in this sequence: Turn off the ignition. Disconnect the wire from the battery terminals. Take off the air filter. Pull out the power of the generator. The flange of the generator

The turbine is stable from about 150 to 170 thousand kilometers, and its future health depends on operating conditions

The second generation of BMW is equipped with 5 engine types with the following characteristics: 116i-petrol engine N13B16U0 with a capacity of 1.6 litres, with a torque of 220 Nb.118i-petrol engine N13B16M0 at a capacity of 170 hp, with a torque of 250 Nm

In order to change the oil in the petrol engine BMW 1 of the first generation, you need to warm the engine to the operating temperature. Open the oil filter lid and let the oil pan out of the filter in the crankcase. Replace the replacement filter unit and the sealant ring