- Details
-
June 04, 2023
-
Written by Jason Hance
If the oil pressure lamp at Audi 100 C4 does not extinguished after starting the engine, the oil temperature is too high. In this case, the light bulb shall be extinguded when the gas pedal is pressed and the engine speed is increased
- Details
-
June 04, 2023
-
Written by Jason Hance
One of the main reasons for the fall in power at Audi 100 with AAA engine is the depressurization of the turbocharged system. This is usually accompanied by a significant increase in fuel consumption
- Details
-
June 04, 2023
-
Written by Jason Hance
The KIA 3 is equipped with two petrol, 1.4 and 1.6 liters. Both the KIA Rio III engines, according to the manufacturer's official data, meet Euro 4 environmental standards
- Details
-
June 03, 2023
-
Written by Jason Hance
To test the accuracy of the ignition coil on the 4th-and 5-cylinder motors of the fourth generation of the fourth generation, it is necessary: Conduct visual inspection of the reliability of the contacts, the presence of trace-mass leakage from the coil. Disconnect all cables from the coil
- Details
-
June 03, 2023
-
Written by Jason Hance
The tension of the gear belt on the Aodi 100 4th generation is checked at the following locations: in the 4-cylinder engine, between the six intermediate ramparts and the preset.
- Details
-
June 03, 2023
-
Written by Jason Hance
Even the new KIA Rio III may appear with an overhanging engine or roller assembly. One of the reasons for his appearance is the penetration of water or mud on a belt. The problem is being cleaned with a special air conditioner for actuals
- Details
-
June 02, 2023
-
Written by Jason Hance
The throttle control at the throttle position on the Mono-Motronic system is tested in this way: Detach the governor's connector by connecting the connector with a potentiometer of potentiometer voltage from a 4-volt battery or a 6-volt charger
- Details
-
June 02, 2023
-
Written by Jason Hance
Fuel injectors test procedure at Audi 100 with Mono-Motronic system: Preheat engine to temperature of 60 degrees (it is sufficient to ride a car for about 10 minutes).Take off the tube. Start the engine and look at the fuel
- Details
-
June 02, 2023
-
Written by Jason Hance
The heat sink fan assembly is activated when the coolant temperature rises to 96 degrees and is switched off after it is reduced to 91 degrees. A temperature sensor is responsible for turning the fan on and off
- Details
-
June 01, 2023
-
Written by Jason Hance
The following straps are used for various modifications of the 4th generation of the 4th generation: 4-cylinder engines running until August 1991