- Details
-
March 03, 2023
-
Written by Jason Hance
Those who had to remove the generator on the VAZ-2108/09/99 are inevitably faced with the lower bolt of the generator that could not be removed, as its head extends into the edge of the longitudinal
- Details
-
March 02, 2023
-
Written by Jason Hance
Work is best performed on an overpass or a forklift. The first thing to do is to leak the entire antifreeze from the cooling system, and then remove the EMG belt and the caster.
- Details
-
March 02, 2023
-
Written by Jason Hance
All coolant from the cooling system must be leaked before operation. After this, you need to loosen the upper hoses and remove them from the bacht with the help of the pliers
- Details
-
March 02, 2023
-
Written by Jason Hance
Even with the condition of the condition of the system of distributed injection VAZ-2108/09/99 the problems with starting the engine in the cold are not rare. The specialists recommend starting the engine by gently squeeing the gas pedal.
- Details
-
March 01, 2023
-
Written by Jason Hance
You need to disconnect the battery minute before starting the disassembly. Then we need to loosen the two metal ducts of securing the duct. The front-screwdriver will fit. Now we need to remove the duct and disconnect the throttle cable
- Details
-
March 01, 2023
-
Written by Jason Hance
Matise can travel both on the 92nd and the 95th gasoline. However, the transition to 95 petrol would require a "chip". For Matisa, it's a "thing" from the Necsiah.
- Details
-
March 01, 2023
-
Written by Jason Hance
The additives in themselves clean the system well, but they cannot become a full-fledged alternative to professional flushing, and they need to use them very carefully. The main rule when using additives is regularity
- Details
-
February 28, 2023
-
Written by Jason Hance
The air filter, air intake and resonator must be removed first. Then disconnect the connector and snapped the spring clips on the gearbox. To test the sensor, measure the resistance
- Details
-
February 28, 2023
-
Written by Jason Hance
The air filter, resonator and air intake need to be removed prior to operation. This will allow the sensor to be reached. Then, disconnect the electrical connector from the sensor by pressing the plastic latch
- Details
-
February 28, 2023
-
Written by Jason Hance
The oil from the top of the oil filler is a common problem for all "classic" VAZ models, not only 2104/05/07