Engine

Details

Written by: Jason Hance

Also available:

Created: 17 February 2023

To remove the generator from the Caliber, you need to perform the following steps: Remove the drive belt with the coolant fluid (no liquid is needed).Soil the steering wheel and small oil tank with the oil, after which they need to be pulled away from the engine

Details

Written by: Jason Hance

Also available:

Created: 17 February 2023

In order to replace the bearings in the generator, you need to do the following: 8 long bolts, 8 long bolts, that stifle the generator.

Details

Written by: Jason Hance

Also available:

Created: 17 February 2023

One sign that the crankshaft shaft is VAZ 2108, 2109, 21099, 2110, 2111 or 2112 need to be changed is the increased oil consumption in the engine

Details

Written by: Jason Hance

Also available:

Created: 16 February 2023

The Kaliber diesel engine is the development of Volkswagen, so many details come from German cars. The GAM belt, in accordance with the regulations, must be changed once in 150,000 km of mileage

Details

Written by: Jason Hance

Also available:

Created: 16 February 2023

Original candles have a number for order SP0ZFR5F11, manufacturer-MOPAR. Tax: NGK: ZFR5F-11-full analogue of ZFR5FGP PZFR5F-11 ZFR5F-11 ZFR5F5F-11 BOSCH: 4308 Platinum DENSO: KJ16CR-L11 IK 16 (iridievs)

Details

Written by: Jason Hance

Also available:

Created: 16 February 2023

If the car has a sudden drop in the battery, the problem may be the wear and tear of the generator's bristle. The lifetime of a generator ticks on VAZ vehicles is long enough, but sooner or later they still have to change

Details

Written by: Jason Hance

Also available:

Created: 15 February 2023

The Focus 2 engine is being polluted quite quickly because of the design features. It is often possible to meet instructions on the adhesive of the subspace

Details

Written by: Jason Hance

Also available:

Created: 15 February 2023

The easy cleaning of the Focus 2 heat sink can be done without removing the cooling radiator. To do this, it is necessary to remove the anchorage on the left side of the air conditioning heat sink and bring it to the side. This will open the cooling system radiator

Details

Written by: Jason Hance

Also available:

Created: 15 February 2023

Thermostat is a very important part of the car cooling system. If the thermostat is lost, the car will be overheated by summer or too long warmed in winter

Details

Written by: Jason Hance

Also available:

Created: 14 February 2023

The EGR system sends the exhaust gas back to the engine and blends them with the engine intake air. This helps reduce the toxicity of exhaust gases. The EGR valve is an electrical device which controls the valve