Engine

Before you begin, you need to disconnect the battery terminals. Then you need to remove the screw and remove the expansion screw with the coolant.

The cup (isolator) of the ignition spark plugs must be white (light yellowish), no crack. The insulator should be dry (i.e. without oil or gasoline), no dense black bloom (or any other colour)

To access the radiator, rotate the 4 screws on the top of the panel. However, when using a console, it is worth remembering that the location of the outside objects in the subspace may lead to overheating or fire

The volume of 1.6 litre is equipped with a system to change the phases of the gas distribution and produces 15 hp more than just the same volume. The change in the phase of the distribution of gas distribution contributes to a smoother engine operation

Many face this problem: the warm-up revolutions are 1400 RPM. Instead of 1,600, idle speed is 600 instead of 750. At the same time, during the warm-up revolutions, can suddenly start to "swim" in the range of ± 400 revolutions

The 1.6-VCT 85-liter engine has come to replace the 1.6-liter engine, developing 105 h.c. The acceleration of the acceleration is 14.3 seconds to 100 km\h. The engine has an impressive torque-141 Nm

1.4 is the parent engine for the Focus 2. The 80 hp developed power is sufficient for a quiet drive, but the engine is most likely to operate on high speeds. In this regard, it is necessary to carefully select the oil and implement it in a timely way

Radiators installed on the Lexus RX300 II as part of the service campaign are also suitable for the Lexus RX330 II, which was designed for the American market

For the first generation, the first generation plant was installed with a volume of 1.6 litres and a capacity of 98 hp. This engine was produced in South Africa, had 2 valves per cylinder and a chain wheel drive

Easyfuel-a fuel tank inlet, free of screw cap