- Details
-
February 01, 2023
-
Written by Jason Hance
If a low oil-pressure lamp is lit on the Lifan Smiley dashboard, it is necessary to check the oil level first. At normal level, further check the pressure in the lubrication system
- Details
-
January 31, 2023
-
Written by Jason Hance
The manufacturer recommends the replacement of the gas-distribution mechanism at Fusion once at 160,000 km, but the dealers are strongly recommended to do so twice as often as every 80,000 kilometres. The belt usually changes for the first time at a distance of 80 to 100 thousand miles. km
- Details
-
January 31, 2023
-
Written by Jason Hance
To replace the candles on Fusion, you need to open the hood and remove the plastic cover. Then remove the cover, which is secured by the two screws, to access the candles. With candles, we need to remove the high-voltage wires, twist old candles and install new candles.
- Details
-
January 31, 2023
-
Written by Jason Hance
If Lifan Smiley has stopped working, first check the condition of the electrical connectors and contacts, and make sure that the battery is properly charged. If there are no problems, we need to remove the starter and check it out.
- Details
-
January 30, 2023
-
Written by Jason Hance
In general, this launch does not indicate a malfunction. When the engine starts in the cold, a little more fuel is supplied to warm the accelerant from the smell of the burning. The smell can vary depending on the quality of the petrol
- Details
-
January 30, 2023
-
Written by Jason Hance
The scrub of the throttle may well be performed on its own. Only a flat-blade screwdriver and an asterisk are required from the tools. It will also require a [ [ fuel system cleaner]] or [ [ fuel system cleaner]], a sponge and a soft cloth
- Details
-
January 30, 2023
-
Written by Jason Hance
Check the gaps with the Lifan Smiley gas distribution mechanism as follows: Disconnect connector 1 and connector 2.Disconnect the oil pressure sensor connector 3.H on the cover of the HBO release of electrical wiring 4
- Details
-
January 29, 2023
-
Written by Jason Hance
The Ford EasyFuel system is a refuelling system that does not have a fuel cap
- Details
-
January 29, 2023
-
Written by Jason Hance
To dismount the ignition unit on the Ford Mondeo III, you must disconnect the PK and the cable connections on the ignition unit. The Ignition Unit is anchored on the cylinder head. Remove the unit from the holder by turning away the four mounting screws
- Details
-
January 29, 2023
-
Written by Jason Hance
Disassemble the generator, Lifan Smiley, in this order: Take off the generator. We unwind the nut, remove the insulator, and unwind the three fastenings of the generator's cap.