Engine

The repair of the Ford Mondeo III thermostat is produced only on the chilled engine. You need to lower the pressure on the system by opening the expansion-hook. Set the clean capacity under the heat sink and detach the lower heat sink or turn the drain screw out of the radiator

To repair the fuel pump on the Ford Mondeo III, it is necessary to disconnect the PAC. Then disconnect the pipe line from the distribution tube. Since the fuel system is under pressure, petrol flows even when the engine is stationary

In the case of the exhaust manifold burnout on Lifan Solano, an unpleasant sound from the engine compartment, similar to the sound of the silencer, appears. To replace the spacer, you need to disconnect the AMBTs.Disconnect connector from the lambda probe

To repair the exhaust manifold on the Ford Mondeo III, it is necessary to use a head with an extension cord to unscrew the internal anchorage of the exhaust manifold and to attach the tubing of the oil probe.

Fuel oil on the Ford Mondeo III is not easy because the Ford Mondeo III fuel tank does not have a flush propeller, and the discharge pipe is located at the top of the tank. To empty the fuel tank it is necessary: Raise the car by a jack and detach the JSCB

The coolant temperature sensor on Liphane Solano is installed in the housing of the distribution tube

Candle on Ford Mondeo III (2000-2007 in.) Original, engine 1.8-2.0: Old code (new code) 1369704 (AGFS22F13J)-platinum; 1315691 (AGFS22IPJ)-iridium; 1216460 (AGFS22CM1)-copper; 1307093-platinum. NGK, engine 1.8-2

The replacement of the engine oil on the Ford Mondeo III is recommended every 20,000 km for petrol engines and 15,000 km for diesel vehicles

If a light oil lamp is lit on the panel of Lifan Solano, the oil pump may have failed. Check it as follows: Pump-off pump (oil must be removed, all belts removed and crankcase removed)

To replace the coolant with the Ford Mondeo III: Use the system pressure with the expansion box