Engine

The cleaning of the throttle on Lifan Solano may be necessary in case of unstable engine idling. To remove the throttle, it is necessary to remove the air hose from the air filter to the throttle

In order to perform many of the repairs to Jill, MK requires a preliminary reduction in the fuel pressure in the car system. For this: 1. Ignition switch 2. Relay the fuse box under the fuel pump.

With problems with idling speed, engine starting, or the dynamics of Gil MK, it is often enough to clean the throttle. It's easy to do. First, loosen the nut cable fastening of the throttle control to the intake manifold and the cable-management arm

When a leak occurs in Lifan Solano radiator, there are two ways to fix it. The first is the use of special hermetics. This method will help you to temporarily fix the leakage, for example, on the road. The second method is to replace the heat sink

The pollution of the idle governor on Jill MK results in an unstable idling speed of the engine. The regulator needs to clean the regulator every 5-10 thousand tonnes. km The procedure consists of the following: Take off the AQL tick

The gas pump at Gil MK is located in the petrol tank fuel module. If poor gasoline is used, a gas pump may be clogged and shall be cleared

At the engine idling speed, the Fan solano is allowed to transmit severe vibrations from the engine to the cooling system radiator. This may cause unpleasant noises, as well as the wear and tear of the rubber hose of the radiator and the subsequent thaw of antifreeze

A check of the exhaust gas by Gil MK for CO and HC may reveal some malfunctions of the vehicle. The concentrations of the substances shall be in accordance with the GB18352.3-2005 standard

In order to replace the gasket of the head of the cylinder, Jill MC will need the keys to 8 and 10, as well as the screwdrivers and passengers. First of all, compress the ears of the small hose of the crankcase ventilation system and move it

One way to cope with the strong vibration of the Lifan Solano engine is to install a flexible insert (leg) into the reception pipe. In this order: Buy a suitable gfra (diameter 48-50 mm) and two recuse of the silencer from the VAZ 2101