Engine

To remove the GRM chain on Honda Accord 7, you need to do the following: (1) Adjust the wheel of the shaft so that its NRMM mark matches the triangular pointer over the skivvie.2) Remove the front wheels and the protection of the drive. 3) Remove the drive belt

The most common problems with the Honda Akcord 8 engines are:-Increased oil consumption (motor oil)-at run over 50 thousand tons. It can reach 1 L/3 thousand kilometers. km The reason for this is the rings of the rings

The throttle control of Mazda 3 (I) should be completely closed. To check the clearance of the throttle cable, move the throttle reel upward to the bottom. If the clearance is not the norm (1.0-3.0 mm

In order to check the operation of the valve of the PCV crankcase on Honda Accord 7, the engine must be started idling at idle and a hose between the valve and the intake manifold. A cracking noise should be heard.

To test the VTEC system at the VTEC Honda Accord 7, you need to: (1) Remove the distribution shaft of the intake valves. 2) Rotate the muff counterclockwise and make sure that it is locked.) If it rotates, it must be replaced

In order to verify the executive mechanism for measuring the phases of gas distribution on the engine L3 Mazda 3 (I), it is necessary to disable the PAC and remove the plate of the hole under the cork. Then, remove the high voltage wire and disconnect the control of the oil valve control valve

To verify that the idling mode is operating correctly on Honda Akcord 8, it is desirable to use a scanner. Verification procedure: 1) Connect the scanner to the connector on the instrument panel

To regulate the valves on the Honda Accord 7, you need a set of keys, a probe, and a 10 Nm chassis dynamometer. The adjustment procedures are as follows: 1) It is desirable to wash the engine so that the dirt does not fall within 0.2)

To check the radial pattern of the Jackass in Mazda 3 (I) :Place the sections of the calibrated plastic wire on the top of the neck, placing them along the axis.

The procedure for replacing the oil and the filter on the Honda Accord 7 is: (1) Praise the engine, put the car on a flat ground and turn off the motor 2) by lifting the bolt and removing the lid on the oil.