- Details
-
December 19, 2022
-
Written by Jason Hance
To install the fuel filter on the Honda Civil, 8 remove the rear seat by unlocking the "M6" anchorage. Remove the access panel from the floor. Detach the 4Rs connector from the fuel tank and the quick disconnects from the fuel pump unit
- Details
-
December 19, 2022
-
Written by Jason Hance
In order to replace the oil filter R18A with the Honda Civil, it is necessary to remove the old oil filter by using the key to remove the oil filter (07HAA-PJ70100)
- Details
-
December 19, 2022
-
Written by Jason Hance
To remove the oil pallet on Mazda 3 (I) it is necessary: Disconnect the ADA, remove the bottom cover and drain the oil. Then remove the oil pan itself, the netted filter, and the compaction ring. Remove the oil and dirt from the body and the oil pan
- Details
-
December 18, 2022
-
Written by Jason Hance
In order to replace the engine oil on R18A Honda Civil 8, it is necessary to heat the engine.
- Details
-
December 18, 2022
-
Written by Jason Hance
To replace the fuel pressure regulator with the Honda Civil, it is necessary to remove the fuel tank block.
- Details
-
December 18, 2022
-
Written by Jason Hance
To remove the coolant pump on Mazda 3 (I) it is necessary to disconnect the CCM and remove the bottom cover along with the spray. Then, drain the coolant from the engine. Then remove and fix the expansion unit of the cooling system for ease of operation
- Details
-
December 17, 2022
-
Written by Jason Hance
To replace the spark plugs on the Honda Civil, 8 detach the ignition connectors and return the ignition coils. Then spin the spark plugs by using the candle-key. With the spark plug on the spark plugs to clean it with a candle cleaner
- Details
-
December 17, 2022
-
Written by Jason Hance
Some owners of Honda CR-V III have positive experience of riding with installed Jetter or Pedal Buster. This device improves the dynamics, gives a faster start
- Details
-
December 17, 2022
-
Written by Jason Hance
To remove the idle governor on Mazda 3 (I), remove the bottom cover. Remove the cover of the JSCB and disconnect it by disconnecting the negative wire. Then remove the idling control valve. Set All in reverse order
- Details
-
December 16, 2022
-
Written by Jason Hance
To replace the spark plugs on the third generation CR-V, it is necessary to remove the nut retaining bolts first, then disconnect the cun' s connectors by shaking them up and pulling them up