- Details
-
December 13, 2022
-
Written by Jason Hance
The first generation of the first generation with the engines 1.6 and 2 litres use unleaded petrol with a octane number not less than 95. Etilled petrol or petrol with a lower octane number may cause a catalyst failure
- Details
-
December 12, 2022
-
Written by Jason Hance
The most frequent use of the drive in the CR-V is the wear and tear of the final distribution shaft. This results in untimely adjustment of the engine as gas distribution engine valves
- Details
-
December 12, 2022
-
Written by Jason Hance
Such a problem is considered to be one of the disadvantages of this model, especially if the 1.3 litre engine is installed. This is due to the untimely replacement of the candles, because of this failure of the ignition coil
- Details
-
December 12, 2022
-
Written by Jason Hance
First, we need to unscrew the six-velope bolt cutout. Then we need to unroll the temperature sensor and move it to the side for convenience.
- Details
-
December 11, 2022
-
Written by Jason Hance
In nine out of 10 cases, poor gasoline can be produced by the difficulty of starting a car. Many owners of Hyundai Accent note that the car is sensitive to fuel quality. It is recommended that the car be refuted in the 92-m petrol stations
- Details
-
December 11, 2022
-
Written by Jason Hance
To unmount the generator, you must complete the steps in the following sequence: 1. Disconnect the wires from the battery, as well as the connectors from the heat sink and the condenser unit fan 2. Detach the heatssecuring bolts
- Details
-
December 11, 2022
-
Written by Jason Hance
To replace the engine oil on Mazda 3 (I) :Install the car on a horizontal surface and warm the engine to normal operating temperature. Then stop the engine and wait 5 minutes. Remove the probe for the oil level
- Details
-
December 10, 2022
-
Written by Jason Hance
The main difficulty of replacing the antifreeze with Hyundai Accent is that there is no cork in the tank. The antifreeze can only be merged through the radiator. So, you need to drain the old liquid from the heat sink (this is approximately 2 to 2.5 liters)
- Details
-
December 10, 2022
-
Written by Jason Hance
First, it is necessary to remove the rear seat under which the gas pump is located in Hyundai Accent. Before removing it, it is necessary to disconnect it from the power supply, start the engine and wait until it stalls so the system is pressurize.
- Details
-
December 10, 2022
-
Written by Jason Hance
Replace the coolant with Mazda 3 (I) only on the cold engine. Tick the thick fabric around the heat sink and slowly turn it counterclockwise until the first stop.