- Details
-
December 23, 2022
-
Written by Jason Hance
To unmount a dislocation motion sensor on Mazda 3 (I) it is necessary: Remove the cover of the JSCB and disconnect it by disconnecting the negative wire. Remove the bottom cover for easy access.
- Details
-
December 22, 2022
-
Written by Jason Hance
For Honda Civil Models, equipped with a working liquid coolant: Eject bolts holding hoses by the GRU hose and remove the hose from the locking mechanism.
- Details
-
December 22, 2022
-
Written by Jason Hance
To unmount the oil control valve of the K20Z motor of the K20Z system on the Honda Civil 8, it is necessary to remove the ankle monitor and panel under the cover. Disconnect the oil management valve connector and the oil pressure sensor connector (KQ)
- Details
-
December 22, 2022
-
Written by Jason Hance
To remove the coolant temperature sensor on Mazda 3 (I) it is necessary to remove ACBA. To gain access to the sensor, remove the air filter and divert exhaust gas recirculation gas from the intake manifold
- Details
-
December 21, 2022
-
Written by Jason Hance
To remove the thermostat on the Honda Civil 8: Remove the engine coolant. Then remove the air purifier assembly. Remove the wiring-harness off the wiring harness, disconnect the radiator lower hose, the coolant intake hoses, and the heater hose
- Details
-
December 21, 2022
-
Written by Jason Hance
To remove the R18A air cleaner on the Honda Civil 8, it is necessary to disconnect the MAF sensor connector "IAT".
- Details
-
December 21, 2022
-
Written by Jason Hance
To remove the ignition coil on Mazda 3 (I), remove the CMC cover and disconnect it by disconnecting the negative wire. Next, remove the air filter. Then disconnect the coil connector and remove it. Perform the installation in reverse order
- Details
-
December 20, 2022
-
Written by Jason Hance
To release the exhaust manifold to Honda Civil ivic 8: Reset the pressure of the fuel. Light the radiator cap and drain the cooling fluid. Remove the panel under the cover. Then remove the hose from the absorber of the fuel vapor (EVAP) and the brake amplifier (s)
- Details
-
December 20, 2022
-
Written by Jason Hance
To remove an asterisk on the Honda Civil 8, it is necessary to: Unmount the drive train chain GR.Unblock the block of the coromyse assembly. Hold the distribution shaft with a flat key and then release the bolt. Remove the distribution shaft
- Details
-
December 20, 2022
-
Written by Jason Hance
To remove the oil pump on Mazda 3 (I), it is necessary to disconnect the CCM and remove the bottom cover with the spray. Then drain the coolant from the engine. Detach and secure the expansion unit of the cooling system for ease of operation