- Details
-
December 16, 2022
-
Written by Jason Hance
The original coolant for Honda cars, including CR-V III, is produced by TCL. This manufacturer produces two colors: green and red. The CR-V requires a green coolant
- Details
-
December 16, 2022
-
Written by Jason Hance
To remove the intake system on Mazda 3 (I), you need to disable the JSCs and remove the bottom cover. Next, remove the connector cover and the PCM.PCM.box, remove the air filter cover, remove the filter entry, and remove the air filter body
- Details
-
December 15, 2022
-
Written by Jason Hance
Some cars have a need to tighten the belt, which has whistling from dampness or too little appetite. The third generation CR-V is an automatic presage
- Details
-
December 15, 2022
-
Written by Jason Hance
The 3rd generation gas distribution mechanism of the 3rd generation vehicle requires periodic adjustments of the valves. Following the manufacturer's recommendation, the setting of the Honda CR-V III valves shall be carried out after every 40,000 kilometres of mileage
- Details
-
December 15, 2022
-
Written by Jason Hance
To remove the fuel injector on Mazda 3 (I) it is necessary: Disconnect the AQA and remove the air filter. Then disconnect the fuel injector connector and remove the quick connector. Also remove the fuel distributor
- Details
-
December 14, 2022
-
Written by Jason Hance
The model fuel filter shall be replaced at the frequency specified in the instruction. A characteristic of the Honda CR-V filter is that it is integrated with the fuel pump fixture and is located in the petrol tank. You can find and order a filter by code: 17048-SWW-E00 (STRINER SET, FUEL)
- Details
-
December 14, 2022
-
Written by Jason Hance
The air filter is located to the right of the Honda CR-V III engine. To get the filter, unlock the latches and open the cover
- Details
-
December 14, 2022
-
Written by Jason Hance
In order to remove the control oil valve on the L3 Mazda 3 (I) engine, it is necessary to disconnect the CQ and remove the plate of the hole under the cork. Then, remove the high voltage wire and disconnect the control valve (OCV) valve
- Details
-
December 13, 2022
-
Written by Jason Hance
The vibration of the engine when the transmission of the power-train mode "P" and the idling speed is due to the activation (at the time of the shutdown of the ACPR) in the Honda CR-V III valve of the exhaust gas discharge valve.
- Details
-
December 13, 2022
-
Written by Jason Hance
The third generation CR-V fuel tank has a capacity of 58 litres. When the on-board computer shows that the remaining fuel can reach 0 km, in fact, there are approximately 5 litres of petrol in the tank