Engine

The fuel filter on Lifan Solano is under the bottom of a car near the petrol tank. The replacement of the manufacturer recommends that every 16,000 people should be replaced. In view of the quality of Russian gasoline, the interval is better reduced to 10 thousand kilometers. km The replacement procedure is as follows:

To adjust the cable with the throttle reel on the Honda Cord 7, it is necessary to: (1) Remove two bolts and remove the cable cover 2) Check the cable. To this end, the tether shall not be more than 12 mm removed from the side to the side

To clean up the throttle housing on the Honda Akcord 7, do the following: 1) Take off the throttle case. 2) Take the carburetor cleaning fluid, pump it with a paper towel, and clear the cover and the inner part of the shell from soot

The high voltage wiring of Lifane Solano has a number of features of the installation. Because of a soft coat, it's hard to lock the wire properly. Therefore, it can be intermittent sparing

Quick-connect couplers are used to connect the hoses of the Honda Achcord 7 fuel system. Before they are disconnected, they will need to be convinced that they are not contaminated to avoid contamination of the fuel

The bolts of the cylinder head on the Honda Chord 7 need to be tightened in the following order:-Middle Bottom bolt-Lower bolt-Lower bolt-bottom bolt-Bottom right bolt-Right screw-right bolt .Moment of gravity-12 Nm

To replace the rear-end leg of the engine, Lifan Solano: Unwind and remove the crankcase protection. Using an NDR from a tree or rubber

The Honda VTEC system allows you to change the height of the valves and the angle of their overlap, depending on the speed of the wheel shaft. It increases engine power at high speed and reduces the fuel consumption at low speed

To reduce the pressure in the Honda. Chord 7 fuel system without using the scanner it is necessary: (1) Turn the ignition switch to the OFF.2 position to pull the main relays of the fuel system (the lower right side of the rail-mounting block in the passenger compartment)

To check the oil pressure Mazda 3 (I) :Remove the lower protective cover of the engine and the oil pressure sensor.