Engine

The procedure for replacing the coolant with the Honda Cord 7 is as follows: 1) Wait for the engine to cool, turn the key to the ON position, put the heater regulators or the air conditioner on the maximum heating, and remove the ignition switch

In order to test the work, the first part of Mazda 3 (I) installed isthmus No. 1 and No. 5 in the prism. Replace when a rule does not match. Maximum beat: 0.03 mm

To change the drive belt to the Honda Accord 7, do the following: (1) Disconnect the wire from the minute tick. 2) Feed the key "on 14" on the caster bolt

To change the cooling radiator on the Honda Actuation 7, perform the following actions: 1) Pour antifreeze 2) Remove the lower hose from the radian.3) If the APPR is connected to the vehicle, disconnect the cooling hoses with the box .4) Remove the top and bottom hoses from the heat sink

To remove the fuel pump block on Mazda 3 (I) it is necessary to disconnect the JSCB and remove the fuel tank. Also remove the cap of the fuel pump by using a special device. Remove the fuel pump unit

To change the spark plugs on the Honda Accord 7, you need to: (1) Leave Minisian tick tick 2) 2 screws and two nuts, remove the protective cover 3) Clear the contaminant. 4)

To replace the fuel filter on Honda Accord 7, you need to do the following: 1) Open the boot and drop the rear seats. Remove the carpet from the trunk. 2) Find a chlug under the mat and twist three vint.3) Disconnect the pump outlet

To remove the throttle probe to Mazda 3 (I) it is necessary: Disable ACBA. Remove air filter and air hose for ease of access.

In order to dismantle the motor oil pan on the Honda Civil 8 (model for Europe) it is necessary to remove the motor oil level sensor protection, then disconnect the motor oil pressure sensor connector.

Test the R18A radiator on the Honda Civil 8 only on the cold engine. To test the heat sink carefully, remove the heat sink cover and remove the coolant to the base of the filler neck