- Details
-
January 08, 2023
-
Written by Jason Hance
The test of the tensioning of the Gil MK is carried out by pressing them in the middle part (between pulleates and rollers) with an effort of about 10 kg. Verification must be performed at least after 5 minutes of engine operation
- Details
-
January 08, 2023
-
Written by Jason Hance
There are two ways to check the timing of the Ignition ahead: by using a tester attached to the diagnostic connector. You must start the warm up engine. The timing of the idle speed shall be 100 + /-20 `;
- Details
-
January 08, 2023
-
Written by Jason Hance
One of the problems of Lifan Solano is the vibration of engine idling. There are several ways to try to fix it: Precise adjustment of the valves. Installation of the groom on the exhaust pipe
- Details
-
January 07, 2023
-
Written by Jason Hance
According to the passport data, the fuel consumption on different modifications of the Jels MK is (100 km) :JL7132U: at 60 km/h-4.5 l, at a speed of 90 km/h-6.2 h.JL7152U: at a speed of 60 km/h-4.6 litres, at a speed of 90 km/h-6.2 h.JL7162U: at 60 km/h-4.7 l at a speed of 90 km/h-4.7 l
- Details
-
January 07, 2023
-
Written by Jason Hance
More often than not, the rear engine of the engine is destroyed on Jill's MK, resulting in trapping and vibrations while driving. In order to change the anvil, you need the keys by 13 (ordinary and tortese), by 10, by 17 and by 18, and also a flat-blade screwdriver and passengers
- Details
-
January 07, 2023
-
Written by Jason Hance
To replace the anti-freeze on Lifan Solano, you need to put the car onto the flat site and remove the left spray of the engine.
- Details
-
January 06, 2023
-
Written by Jason Hance
In order to remove the generator on Jill MK, you will need the keys 10 and 13. The order of the action is: Minus the minute of the battery. Take off the rubber cap on the generator.
- Details
-
January 06, 2023
-
Written by Jason Hance
Before taking off the retractor against Jill MK, we're taking off the starter myself. To do this, disconnect all wires and roll 2 mounting bolts
- Details
-
January 06, 2023
-
Written by Jason Hance
To replace the water pump on Lifan Solano, we will need keys for 8, 10 and 13, as well as a flat-blade screwdriver. The work progress is as follows: Remove the protection and the sprayproof of the engine. Pour antifreeze. Take off your nap, hydraulic amplifier, air conditioning. Take off the middle leather of the GRM-belt
- Details
-
January 05, 2023
-
Written by Jason Hance
The manufacturer of Jill MK recommends that you change the antifreeze to every 30,000 people. km travelled. The procedure is simple enough: Open the radiator cap, uncover the cork and drain the liquid into a pre-cooked capacity of about 7 liters