Engine

Searching for fan failures on the Ford Mondeo 3

Searching for fan failures on the Ford Mondeo 3
If the fan is not operating in any of the locations, the fuse box should be checked first. If the fuses are in order, we need to check the switch by dismounting the control knobs.

Replacing the gasket of HBCD

Replacing the gasket of HBCD
If Lifan Smiley leaks the head of the cylinder block, we change it in the following order: We take the screwdrivers (flat and cross-shaped), the pliers and the keys by 8 and by 10

The tip of the spark-ignition coil on the Ford Mondeo 4

The tip of the spark-ignition coil on the Ford Mondeo 4
Many owners of Ford Mondeo IV cars face the problem of a broken spark-ignition tip. This problem is particularly relevant for Ford Mondeo 4 vehicles with engines of 1.8 and 2.0 liters

Problem with the Ford Mondeo 4 pump

Problem with the Ford Mondeo 4 pump
The problem with the gas pump is often found in the Ford Mondeo 4: the gas pump simply stops working. It is located under the floor of the rear seat, but access to it is complicated by the absence of a chuck in the floor. The fuel tank will have to be removed to remove the fuel pump

Replacing the [ [ knee salon]] with [ [ Lifan Smily]]

Replacing the [ [ knee salon]] with [ [ Lifan Smily]]
In order to change the splashers of the call to Lifan Smiley, you need: For the front side: Remove the right front wheel.

Turbine problem with the Ford Mondeo 4

Turbine problem with the Ford Mondeo 4
It happens that the turbines in cars with EcoBoost engines are getting out of order quite early-after 70-80 thousand km. mileage. The most common reason for this is the strict use of powerful cars: constant acceleration or long drive at high speed

Pressure switch check on the Ford Mondeo III

Pressure switch check on the Ford Mondeo III
To test the pressure sensor on the Ford Mondeo III pressure sensor, disconnect the hose from the pressure sensor and cover the hole with the finger. Using your partner to start the engine and bring it to medium speed (about 2000 rpm)

Replacing the Lifan Smily fuel injectors

Replacing the Lifan Smily fuel injectors
Replacement of fuel injectors on Lifan Smiley in this sequence: Reset pressure in the fuel system

Checking the Ford Mondeo III fuel injectors

Checking the Ford Mondeo III fuel injectors
Fuel injectors shall be tested on a cold engine only. To check the voltage of the valves at the engine running, and to connect the LED with the LED (not the reference lamp)

Audit of the leakproofness system on the Ford Mondeo III

Audit of the leakproofness system on the Ford Mondeo III
If white precipitations are present around the radiator water hoses, the engine or fan of the Ford Mondeo III heater, the locations of their compounds are non-leakproof and tight, the fragile and cracking hoses need to be replaced