Engine

To replace the thermostat it will take about a liter of antifreeze and a key of 10. First of all, it is necessary to leak the antifreeze from the radiator through the drain neck on the left. Then we need to remove the fat hose from the expanse, then remove the tank.

Many owners of the first generation of [ [ Focus]] are faced with the appearance of a [ [ drive belt]]

If the fan of the Lifan Smiley cooling system is not activated, it must be checked. It runs like this: Let the engine cool down. Turn the ignition switch to the ON position.

The plastic tube, which is divided on one side, is located just behind the grille, between the lights, on cars with engine 1.8 and 2 liters. This pipe is pretty often burst and antifreeze starts out of it. As a rule, this happens once a year and a half

Not all vehicles with an engine of 1.6 litre are equipped with plastic engine covers. If the cover has not been supplied at the plant, it can be installed on its own. No rework is necessary, just buy the cover, install the fastenings, and lock it on them

The motor oil on Lifan Smiley follows the standard procedure, but there are several points to note. The procedure is as follows: Wait for about 15 minutes.

The video or seat belt on the Ford Focus 2 appears as a rule when the engine is started in cool weather. The main reason for the whistling is that the belt is not closely adjacent to some of the snippets

The main cause of the fuel pump failure is poor fuel. The failure of the gas pump may be manifested in periodic traction failures (especially in case of abrupt acceleration), loss of engine power, engine may be lost

Check the tensioning of the straps on Lifan Smiley in the following areas of Progib A must be 8.5-10.5 mm (new belt) 10-12 mm (working belt)

The protection of the crankcase is made of steel or composites. Compositing is easier, but less steel in strength. Composite protection does not rust, but it is not very relevant, as steel serves at least 5 years