- Details
-
February 11, 2023
-
Written by Jason Hance
The 3MZ-FE engine is installed on RX330, and it will not be able to make a major repair with a meltshop. This engine is also prone to the emergence of oil-water and overheating. Motor was installed only on cars intended for the US and Canadian markets
- Details
-
February 10, 2023
-
Written by Jason Hance
Engines 1.4 and 1.6 (100 h.p.) do not have a decorative plastic cover ("stove" in the people). However, you can install the cover yourself. Volvo S40 and C30 will be fine without pay. Fine.You can install the cover from the Chevrolet Niva or Ford Duratec 1.8 and 2.0.
- Details
-
February 10, 2023
-
Written by Jason Hance
The reason for the overheating of the Ford Focus 2 engine may be more than one. 1. It may not function or move to second speed fan. It will quickly lead to overheating in warm weather. 2. Highly contaminated radiator
- Details
-
February 10, 2023
-
Written by Jason Hance
With the current radiator, the owners of machines operating in large cities are the most frequently encountered
- Details
-
February 09, 2023
-
Written by Jason Hance
The chain drive of the gas distribution mechanism was installed on the motors Zetec Rocam (it is Duratec). This is an 8-valve engine with a capacity of 1.6 litres and a capacity of 98 hp. A similar 16-valve engine was equipped with a GRM-belt
- Details
-
February 09, 2023
-
Written by Jason Hance
The most likely to disperse is the debris of the crude oil cleaning filter (splash pump). The gas pump is in the back seat and access to it, you need to remove the gas tank. Sometimes it is better to replace the splits with a new one.
- Details
-
February 09, 2023
-
Written by Jason Hance
In order to relieve the pressure in the fuel system, Lifan Smaili may wait two to three hours after the engine is stopped-it must be reset independently
- Details
-
February 08, 2023
-
Written by Jason Hance
The contaminated throttle control may cause engine instability at idle speed. The vehicle may also be lost periodically. Getting started is 30 minutes after engine shut down
- Details
-
February 08, 2023
-
Written by Jason Hance
Candle replacement requires a candle key at 16. First of all, it is necessary to gently remove the engine cover without breaking it. When installing new candles, it is necessary to watch that the candle is curled uniformly, without skewed
- Details
-
February 08, 2023
-
Written by Jason Hance
With a properly configured engine management system on Lifan Smiley, the vibration may be caused by the wear of one of the motor pillows. The rear of the powertrain is most often required to change. For this: Take the printheads on 13, by 15, and at 16.4.