The repair of the Ford Mondeo III thermostat is produced only on the chilled engine. You need to lower the pressure in the system by opening the expansive butterfly. Set the radiator to the clean radiator and unscrew the radiator's lower hose. Remove the hose from the coolant. disconnect the hose by releasing the hoses on the thermostat. Clear the thermostat enclosure, After removing the three mounting screws, cleaning up all the seals and installing the new enclosure thermostat with the engine block. Preprocess the new gasket seal. Next, connect the hose and fastening the chant duct to the level. To heat the engine at medium speed and check the place of the leak.
- There is a need to put pressure on the system by opening the expansion bug.
- Install a clean radiator and detach the lower radiator hose, or turn the drain screw loose.
- About three liters of coolant.
- Disconnect the hose by releasing the hoses hose on the thermostat.
- Remove the thermostat enclosure by turning away the three mounting screws.
- Clean all the seals and install the new enclosure thermostat with the engine block.
- To process the new gasket with a warm seal.
- Then connect the hose and cement the hose.
- To prove the coolant to the level.
- Heat up the engine at medium speed and check the place of the leak.
- Close the compensation tank.
